0
What else can I help you with?
How do you adjust a hydro clutch on a 1997 Chevy 1 ton?
YOU CAN"T, There is NO adjustment, Time to replace the clutch
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
How do you adjust the clutch on an 89 Chevy 2500?
You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.
Loud squealing noise every time push in clutch is it the throw out barring how much to replace entire 1990 Chevy S-10 pickup truck clutch someone saying 700?
Yes it is most likely the clutch release bearing and i would say 400 to 600 is about normal for clutch replacement.
How much to replace vw jetta breaks?
It'll run you around $500-$800. The brake rotors have to be replaced at the same time as the pads because the original rotors were extremely thin.
When does Honda recommend a clutch replacement for a 1999 prelude?
There is no recommended time to replace the clutch. You replace it when it wears out. That will depend on how you drive. It may last 100,000 miles or you may wear it out in 20,000 miles.
How to detemine when to replace clutch plate?
Get car up to about 15 miles an hour in fourth gear. Dip the clutch untile slip occurs. Then build revs and release clutch at the same time. If revs continue to build then the clutch plate friction lininhs are worn and it is time for a new clutch.
Why wont my clutch lever work on your Yamaha blaster?
Well cable could be froze up. Replace the clutch cable. If cable is working adjust cable. If the clutch cable is adjusted then it's time for a new clutch
What would cause stick shift to jam when car is on and clutch pressed but shift fine when car is off without stepping on clutch?
sounds like clutch needs adjustment or time to replace it
Can you fix a sipping clutch with out having to replace it?
This depends on how worn the clutch components are, with some vehicles the clutch requires frequent adjustment to compensate for the friction plate wearing under usage. However if the clutch has been adjusted frequently and the 'slipping' remains, I'm afraid it's time to replace those internals.
Why is it that my Vw jetta 1998 won't shift?
I believe your clutch master cylinder is bad. I replaced mine just last year because I couldn't put my car into gear. Every time that happened I had to open the hood and free the clutch lever because the clutch master cylinder went kaput.
What can the problem be when a 91 Nissan sat for a long time and the clutch pedal is stuck to the floor?
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
