sounds like clutch needs adjustment or time to replace it
When you are shifting gears, your RPMs will go down because your clutch is being pressed. If your RPMs don't go back up when you release your clutch, you should see a mechanic.
Did you break the clutch cable or the clutch disc?Clutch cables break because they just wear out. The axle can't do that.What normally causes clutch discs to fail is overstress: you pushed the clutch in without letting off the gas, downshifted at too high a speed, or souped up your engine without putting a stronger clutch in the car. Axles can't do that either.
A worn out clutch release bearing would cause a whining sound when you put your foot on the clutch.
A slipping clutch.
Oiling the a/c clutch will cause the clutch to slip and burn up........
If the clutch switch failed then the car will not start unless the switch is bypassed. The purpose of a clutch safety switch is to prevent the car from dangerously starting, so when it malfunctions that car will not start without it switch off.
bad clutch cable, or not enough oil on the clutch plates.
Compressor/clutch is about to go bad, if has a serpentine belt when it does no driving the car, better get it checked while car can drive, oh ya stop using AC till its checked.
There is no hydraulic fluid in the transmission. However, there is hydraulic fluid in the clutch system. If the clutch fluid reservoir is empty it would cause clutch not to operate.
I would suspect a weak clutch slave cylinder or clutch master cylinder which may be preventing the clutch from disengaging fully; The slave cylinder is connected hydraulically to the clutch master cylinder. The clutch master is where you add fluid.
The maximum weight limit for many stepping stools is 300 pounds. If a person exceeds the weight limit it can cause the stool to break and can cause injuries.
not stepping down from power i believe,