answersLogoWhite

0

It is about $118.00 for one, plugging in the oxygen sensor isn't so bad, but the plug itself goes up into the frame of the car and seems to dissappear somewhere inside the car. Im having trouble finding this myself.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the oxygen sensor on a 1988 Toyota?

The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.


Where is the oxygen sensor on a 1988 cadillac deville?

The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.


Where is the oxygen sensor on a 1988 Chevrolet celebrity?

If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.


Does a 1988 Ford Ranger have o2 sensors?

I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )


Where is the oxygen sensor located on a 1988 Honda prelude fuel injected?

The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.


Where can you get wire diagram for oxygen sensor on a 1988 Bronco ll?

Chiltons auto manuals have good diagrams, your oxygen sensor is on your exhaust in front of the catalytic converter.


Where is the oxygen sensor 1988 regal?

oxygen sensors are on the exhaust pipe close to the engine. Some are on the exhaust manifold. some may have an upstream and a down stream sensor.


How do you replace oxygen sensor on 1988 Honda CRX?

To replace the oxygen sensor on a 1988 Honda CRX, first, locate the sensor, which is usually found on the exhaust manifold. Disconnect the negative battery terminal, then unplug the old oxygen sensor's electrical connector. Use a wrench or oxygen sensor socket to unscrew the old sensor, and then install the new sensor by threading it into the exhaust manifold and tightening it securely. Reconnect the electrical connector and the negative battery terminal before starting the engine to test the installation.


Where is the oxygen sensor on a 1988 dodge diplomat?

On top of the exhaust manifold on the drivers side.


Does the 1988 ford mustang 2.3 liter have just 1 oxygen sensor?

Yes.


How to Identify signal wire on oxygen sensor for 1988 ford ranger 2.9l?

you can breath


Where is the oxygen sensor on 1988 gmc jimmy?

they're usually after the cat-con on the exhaust...