0
Turns out, the directions are in the user's manual! But, since I didn't look there, and to save others from having to look it up, here's how to do it (for a 2004 525i):
- Insert a screwdriver or key into the slot in the license plate bulb bracket and slide the bracket to the right until the left edge drops out of its latched position
- Then, with your fingers you should be able to slide the bracket to the left to release the right edge of the bracket
- My license plate frame obstructed the right edge of the bracket a little, so I had to remove the left screw attaching it to the car, and screwed it back in after the bulb bracket was reinstalled
- With a slight wiggle, the bracket should drop all the way down, allowing you to easily get to the bulb and replace it
- Reverse the steps to replace the bracket
What else can I help you with?
How do you replace the license plate bulb on a 2004 Honda cr-v?
how to replace the license plate bulb on a 2004 Honda cr-v
How do you replace license plate bulb on 2004 crv?
how do you replace a honda crv licence plate bulb on a 2004
How do you replace the license plate light bulb on a vw?
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
How do you replace bulb on 2005 BMW 525i fog lamp?
how do i remove and replace my fog lamp bulbs on my 2006 bmw 525i
How do you replace the license plae bulb on a Mazda tribute?
You need to unscrew the whole cover panel for license plate.
How do you replace the license plate bulb on 1999 Cadillac eldorado?
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
How do you replace the license plate bulb on a 2005 Lexus RX330?
Ask your car dealer...
How do you replace Volvo v70 license plate bulb socket?
You need a torx screwdriver....
How do you replace license plate bulb on 1999 ford contour?
you buy a new one
How do you replace the license plate bulb on 2000 Mercedes S430?
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
How do you replace license plate bulb on 2003 Chevy Tracker?
To replace the license plate bulb on a 2003 Chevy Tracker, first, locate the license plate light assembly at the rear of the vehicle. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise and then replace it with a new bulb, ensuring it’s secure. Finally, snap the lens cover back into place and test the new bulb to ensure it works.
Chevy Tahoe's license plate bulb?
A Chevy Tahoe's license plate bulb can be used to light up the license plate. In the dark the license's plate will still be visible.
