0
The engine temperature sensor on a Volvo 240 is typically located on the engine block, near the thermostat housing. It is usually positioned on the cylinder head or intake manifold, depending on the specific engine variant. To access it, you may need to remove any surrounding components for better visibility. Make sure to disconnect the battery before attempting to work on it.
What else can I help you with?
Where is the engine temp sensor on a 1993 Volvo 240?
The engine temperature sensor on a 1993 Volvo 240 is typically located near the thermostat housing on the engine block. It is usually mounted in a threaded port and can be identified by its electrical connector. To access it, you may need to remove any covers or components obstructing the view. Always ensure the engine is cool before attempting to inspect or replace the sensor.
Sensor Volvo 240?
Which sensor ???
Where is the coolant sensor located on 1990 Volvo 240?
The coolant temperature sensor on a 1990 Volvo 240 is typically located near the thermostat housing on the engine block. It is usually positioned on the cylinder head or the engine block itself, close to where the upper radiator hose connects. To access it, you may need to remove some components for better visibility. Always ensure the engine is cool before attempting to locate or replace the sensor.
Where is the crankshaft position sensor on 92 Volvo 240 B230F engine?
it is located on top of the bell housing behind the engine
How do you reset engine Light on 1991 Volvo 240 DL?
how do you reset engine light on 1991 volvo 240
Will a bad knock sensor stop a Volvo 240 from starting?
I have a 240 and with the knock sensor unplugged it will still start so I would have to say no.
How do you replace the O2 Sensor on a 1993 Volvo 240?
To replace the O2 sensor on a 1993 Volvo 240, first, locate the sensor, which is typically found on the exhaust manifold or downpipe. Disconnect the electrical connector and use an O2 sensor socket or wrench to unscrew the old sensor. Install the new sensor by threading it into the same location, tightening it securely, and then reconnecting the electrical connector. Finally, start the engine and check for any error codes or issues.
Where is the bulb failure sensor in a 1991 Volvo 240?
In a 1991 Volvo 240, the bulb failure sensor is located in the rear driver’s side corner of the engine compartment, mounted on the inner fender. It is part of the vehicle's lighting system, designed to monitor the operation of the vehicle's exterior lights. If a bulb fails, the sensor triggers a warning light on the dashboard. Make sure to check the connections and functionality if you suspect issues with the sensor.
Is the 240 Volvo engine an interference fit motor?
Yes
What would make a Volvo 240 DL 1986 temperature gauge read hot even without the engine running?
Check the temperature sensor. You should be able to find a resistance value in your manual. If it is within specs, check to make sure the wire to the sensor is not grounded. Quick check would be to unplug the wire from the sensor. If the temperature goes down to cold it is probably the sensor. If not, there could be a short in the wire to the sensor. Worst case scenario is that the guage itself is faulty but the sensor or the wire is more likely.
How many horsepower does the engine in the 2015 Volvo XC70 have?
The 2015 Volvo XC70's engine produces 240 hp @ 5600 rpm.
How many horsepower does the engine in the 2013 Volvo S80 have?
The 2013 Volvo S80's engine produces 240 hp @ 6400 rpm.
