on top of bellhousing, behind head, pass-side
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
it is located on top of the bell housing behind the engine
in the distributor in the rear of the engine. sometimes known as a hall sensor
It located on the drivers side engine compartment over top of the transmission you will need to remove the battery tray to install'
On a 1989 Volvo 240 DL, the crankshaft position sensor is typically located near the crankshaft pulley or the front of the engine, often mounted on the engine block or transmission bell housing. It is positioned to detect the position and speed of the crankshaft as it rotates. In some cases, it may be integrated with the ignition system components. Always consult the vehicle's service manual for precise location and installation details.
Ohh my little one.... After two days of on-line searches and two Volvo manuals I learned that there are no crank sensors referred in the manuals. I bought it as a "Crankshaft Position Sensor'' but it`s referred as "RPM Sensor" It`s position is on TOP of the flywheel next to the engine. Directly UNDER the distributor cap and the camshaft sensor cover. I J077535
were is the camshaft position sensor on 1999 Volvo s80 turbo
In a 1987 Volvo 740, the crank impulse sender, also known as the crankshaft position sensor, is typically located near the flywheel at the rear of the engine. It is mounted on the transmission bell housing, positioned to detect the rotation of the flywheel. Accessing it may require removing some components for better visibility and reach.
on the right side of the engine at the back at the righ end of the cam shaft
PO120 EOBD Code Throttle position sensor A/ Accelerator pedal position sensor A/ - circuit malfunction.