To boil it, better slit a small hole in the bottom of the egg. Then put it in the water.
You get a hard boiled egg, and put a hole in it.
What you need: 1. eggs 2. needles 3. Bowl 4. Vinegar (ordinary) Put the eggs in the bowl. Pour the vinegar over eggs till the eggs are fully covered. Leave for 3-4 hours. Take out the egg. The shell is now soft. Insert as many needles as you wish. You may also use a syringe and put some color if you wish to. Leave the eggs to dry. When dried the shell is again as hard as originally. Done! AHJ
Fill a small pan with water (about two thirds full) and put on heat to bring up to a rolling boil, take your fresh egg and make a small pin hole in the rounded end, this end has a small air sack, the hole will help prevent the egg cracking open in the boiling water. Place the egg on a large spoon then lower into the boiling water, cook for 3 minutes, remove, pad dry with kitchen paper and serve straight away in an egg cup with lots of toast soldiers.
Fill a small pan with water (about two thirds full) and put on heat to bring up to a rolling boil, take your fresh egg and make a small pin hole in the rounded end, this end has a small air sack, the hole will help prevent the egg cracking open in the boiling water. Place the egg on a large spoon then lower into the boiling water, cook for 6 to 7 minutes, remove from the water and refresh under cold running water to stop the black ring forming around the yolk. Peel and eat.
You use a thin knitting needle to make a small hole in both ends of the raw egg. Poke the needle inside to burst the yolk. Then gently blow through one hole until the insides of the egg has oozed out of the other hole, leaving an empty egg shell. You can now paint the egg shell as much as you want.
money or small toys.
To suck an egg, you make a small hole in each end of the egg. Put your mouth to one hole and just suck the raw egg out of the center (the other hole is ventilation to allow air to push out the egg contents). To suck an egg into a test tube: 1. Put the egg on top of a test tube. 2. Soak it in a cold bath. 3. Wait a while and eventuallly the egg will be sucked into the test tube! This happens because when the test tube comes into contact with cold it will feel the need to pull, so it sucks the egg in. If you want to get the egg back out: 1. Hold the test tube upside down in a bath of hot water 2. Eventually the egg will slide out! As you may know, heat makes things expand. So when the test tube is in a hot bowl of water, it expands until it is big enough to let the egg through.
To safely and effectively blow out eggs for decorating, first wash the egg thoroughly. Use a pin to make a small hole at the top and bottom of the egg. Gently blow through one hole to push the egg contents out of the other hole. Rinse the empty egg shell with water and let it dry before decorating.
1. Get a Egg 2. Boil the egg 3. Drill a hole in the egg but not to the bottom (about half way and dont throw away remans) 4. Put some fuse in to hole (strip of rolled up cloth covered in spirits) 5. Put some gunpowder in to hole to fill it half way. 6. Put back in a little of the mangaled egg Now all you have to do is light the fuse and run!!! Hope this helps Dynofly :-D
Get a fake egg that opens. Then Paint it white all around. Wait till it dries. Next take a ordinary Quarter and put it and the egg. And Walla There you have itHOW TO BUT A QUARTER IN A EGG
Use a small hose or funnel and put it in the dipstick hole