0
What is the difference between high frequency signals and low frequency signals in terms of 1 distance that can be traveled 2 transmit power required and 3 susceptability to EMI?
Wiki User
∙ 12y ago
mota
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
If you are here how long does it take to get theere?
The time required is (distance from here to there) divided by (speed at which you make the trip) .
What quantity is hertz used to measure?
One would measure hertz by using an analog ammeter. Hertz can be measure in kilohertz. Hertz is the unit used to measure frequency. Any instrument that measures frequency can be used to measure hertz. 1 hertz is 1 cycle per second. By radio frequency.
How do you increase the wavelength of a wave?
The expression for the energy of a mechanical wave is E = 2 m pi2 nu2 a2 m - mass of the particle in the medium nu - frequency of the wave a - amplitude of wave. So to increase the energy we may increase the frequency or amplitude of wave. If m is larger then more energy is required to have the same amplitude. Hence with increased mass more energy will be stored.
How much mile required for 1 kg paneer?
Not possible to compare. Mile is unit of distance, kg is unit of weight
What is the difference between compulsive and compulsory?
compulsive means resulting from an irresistable urge or pressure to do somethingand compulsory means required by a law or a rule. It is kind of mandatory.
Is frequency the time required for one complete cycle?
Frequency is 1 divided by the time required for each cycle.
What is difference between oscillator and regulator ic?
oscillator is which oscillates to a required proportion in order to generate signal with required frequency. whereas, regulator limits the signal to a predefined value and offers a constant out put through out
What is the difference between diffrencial relay and a distance relay?
They're completely different, used for different applications (usually). A distance relay uses both current and voltage. A differential relay uses only current. A differential relay usually has harmonic restraint capability, while distance relays ideally track system frequency. Differential relays require fast operation, while distance relays may not be required to operate as quickly. Distance relays have more issues with operating for out of zone problems than differential relays. There are many more, but this gives an idea.
What is the minimum sample rate required to to record a frequency of 20 kHz?
According to the Nyquist theorem, a sample rate of double the frequency is required to record it, so 40 kHz .
On what frequency can you listen to Radio Soft?
The frequency required to listen to Radio Soft varies from city to city. If one is in Copenhagen, the frequency would be 95.0. Alternatively, if one is in Roskilde, the frequency is 107.7.
What is threshold frequency in photoelectric effect?
It's the frequency at which each photon has the amount of energy required to separate an electron from an atom in the target substance.
Difference between system tick and processor clock?
Based on the Crystal used in the circuit, and the divisor selection, the processor clock frequency is obtained the tick time is the min clock cycles required to do a nop operation
Where you have requirement of capacitor in electronics?
A capacitor is required in electronics when we are charging and frequency circuits.
What is the difference between anchorage length and development length?
Anchorage length is the required distance to transfer a load and is dependent on the materials used. Development length is the length of the reinforcement bar or rod required to transfer the load safely to another bar.
What is the required distance between emergency exit doors for industrial buildings?
what is the required distance beteen emergaency exit dorrs for industrial buildings
What is the required Distance from urinal to urinal?
there isn't a required distance, but men should be about a foot away and women should be about 8 inches away
How is the relative frequency for a class computed for qualitative data?
It is the number of times (frequency) that a value in the required class is observed divided by the total number of observations.
