answersLogoWhite

0

The inducer motor runs to create a draft for the ignition process in a heating system. If there is no ignition, it could be due to issues with the gas supply, faulty ignition components, or a blocked flue. It is important to have a professional technician inspect and troubleshoot the system to determine the exact cause of the problem.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

Should the air induction blower continue to run after furnace blower motor starts?

If you are refering to the inducer motor( the one with the little wheel that you see when you take your units doors off) Yes it should keep running when your blower motor is running and before ignition to create your draft and during to rid the gases out your flue Hope I kept it simple


Blower motor runs with ignition off?

probablly a bad ignition switch or blower motor not sure on that should run without power


Why does blower motor continue to run on a 2000 Chevy Impala after ignition is shut off?

Your blower motor working even after the car is off is a good sign. This means that the car's system is preventing your car from overheating.


How do you know if ignition switch is in run position?

if the starter is not spinning and the truck motor is running


What happens when the ignition is turned on in a car engine?

The ignition system is powered up and ready to run the vehicle.


What is the timing on a 1978 cj7 304 the motor is out of an ambassador the distributor does not have points?

18436572 should be the same for the 304 v8 with either ignition as the motor is timed to make it run in a balanced smooth manner. After the electronic sends voltage to the coil the system functions the same as a conventional breaker system.


Having problems with 1972 Evinrude boat motor most times it starts first go. run the motor for a few minutes and try to kick it again it doesn't turn over any ideas?

The 1972 model Evinrude has a battery powered ignition system, meaning that battery voltage is needed to power the ignition. Around 1978-79, the CDI ignition was introduced, in which a dual function stator was incorporated, to not only provide voltage to charge the battery, ( which is all the earlier system stator does ), but also supplied voltage to operate the ignition system. With the advent of the CDI system, all the battery was used for is voltage to operate the starter motor. Hence, once the engine was running, the battery was no longer needed. The ADI ( alternator driven ignition ), used in the 1972 model, would not run without continuous voltage that is supplied by the battery. I would suspect a problem with either the battery, or the charging system. Also, ensure that the battery cables are clean and tight at the connections, and in overall servicable condition.


How do you get an 1985 5th ave to run with out the computer on air filter assy just want to get the motor to run with a toggle and push button?

Replace the computer with a MOPAR electric ignition kit #p3690426. This will by pass the lean burn system and you can hot rig a starter switch from there


What is the ignition timing for a 88 5.7L Chevy truck?

i need the ignition timing for 88 chevy 5.7 ... 350 motor i had the truck on 4 but still bad don t run good


Will the pick up coil in a distributor keep you from hearing the fuel pump run a couple of seconds when you turn the ignition on in a 1993 Taurus 3.0 you replaced the ECM and the ignition coil?

No. The fuel pump should run for 2 seconds when the key is cycled from off to run, regardless of whether there is a problem in the ignition system or not.


How can you wire a chvy 350 motor up to run?

It depends on the year of the vehicle, whether it's throttle body injected, electronic ignition...


Can you run 480 volt motors in a 380 volt system?

Can I run 480 volt , 60 HZ motor at a 380 volt , 60 Hz system?