take it to a JOHN DEERe
dealership
Some did, others did not.
Yes, the gas cap on a John Deere SRX75 riding mower is vented. This venting allows air to enter the fuel tank as fuel is consumed, preventing a vacuum from forming that could hinder fuel flow. It's important to ensure that the vent is clean and functioning properly for optimal performance. If you suspect issues with the gas cap, consider checking it for clogs or damage.
believe it or not,I used a Turkey Baster to drain my tank to change a fuel filter.
If you are talking about the Scotts S1642 made by John Deere, there is no fuel pump. It is a gravity fed system
remove fuel line and drain or run your mowe till it is out of gas.
can you show me the timing mark on the john deere 450G bulldozer
1.5 to 2.3 GPH as per the John Deere brochure
On a John Deere 214 mower, the ignition coil typically has two primary connections: one wire connects to the spark plug, while the other connects to the ignition module or the mower's electrical system. The spark plug wire delivers the spark necessary to ignite the fuel-air mixture in the engine. It's important to consult the mower's service manual for specific wiring diagrams to ensure proper connections.
No fuel filter!
To drain gas from a John Deere riding lawnmower, first ensure the engine is off and cool. Locate the fuel line, typically a rubber hose connected to the fuel tank, and use pliers to pinch it closed. Place a container underneath the fuel line and carefully disconnect it to allow the gas to flow out. Alternatively, you can use a siphon pump to safely remove the fuel from the tank. Remember to dispose of the gas properly according to local regulations.
The fuel shut-off for a John Deere 350G excavator is typically located near the fuel tank or on the fuel line. It may be a valve that you can turn to stop the fuel flow to the engine. For precise location details, it's recommended to consult the operator's manual or check with a John Deere service technician.
Answer The Question Clown!