JOHN DEERe 210 38" mower deck drive belt: M40223 secondary drive belt
How is the belt position on the front 48" deck on a JD F525
Check out crigby's John Deere deck page. It shows the belt routings for most of the JD mowers. See the link below.
To change the drive belt on a John Deere LT150, first disconnect the spark plug to ensure safety. Remove the mower deck by detaching the belts and any necessary bolts, then slide the deck out from under the tractor. Locate the drive belt, release the tension by adjusting the idler pulley, and remove the old belt. Install the new belt by threading it through the pulleys as per the routing diagram, reassemble the mower deck, and reconnect the spark plug.
The belt is a M74747 which is 1/2" x 105"
For round fender 110. To remove \ replace drive belt that has slipped off. Remove 2 of the 3 bolts from large pulley on transmission right side. This will allow enough access to slip belt onto pulley. Replace bolts.
I'm not to sure but I'm trying to fit my jd bug headset on my mgp I am changing them over later on today
It will depend on the style manual for the situation. Either can be correct, but I see JD most often.
the best an strongest deck on the market is mgp the style is slamm and jd bug are for safty and portableness
I need this too if anyone has the info I would appreciate it. Thanks!
Per John Deere operators manual: 312, 314, 316, 317, 300, 140, 120. I have been using my 48 inch deck since 1983. -- Dave
JD Souther goes by JD.
Jd Dillard goes by JD.