this is good question & i hope that answer will also good.
Contact a Fiat dealer.
To remove the spare tire from a 2008 Fiat Ducato van, first, locate the spare tire compartment, which is typically found underneath the rear of the vehicle. Use the provided jack handle or a wrench to loosen the securing mechanism, usually a winch or bolt, that holds the tire in place. Once loosened, carefully lower the spare tire down and detach it from the securing system. Finally, lift the spare tire out and store it safely.
The (emergency) spare wheel is under the hood, over the motor, with the jack and wheel spanner.
rear of van under neath bolt
Weight with fuel, spare and tools - 704cc 690k, 899 - 710k
the bonnet lever on a fiat brava is by the clutch pedel and has a red handle this may be the same on the bravo
In the Fiat Punto MK2, the spare wheel is typically located in the boot (trunk) of the car, underneath the floor panel. To access it, you usually need to lift the floor mat or panel, which may be secured with clips or fasteners. Some models may also have a tire repair kit instead of a spare wheel, so it's advisable to check your specific vehicle configuration.
The OBD II connector on the 2012 Fiat 500C is located just above the hood release handle on the left side of the dashboard.
To attach a spare wheel to a Fiat Scudo, first, ensure the vehicle is on a flat surface and secure the parking brake. Remove the wheel cover if applicable, then use the wheel bolts to attach the spare wheel to the hub, aligning the holes properly. Hand-tighten the bolts initially, then use a wrench to tighten them in a crisscross pattern to ensure even pressure. Finally, replace any covers and lower the vehicle if it was raised.
In the boot under the carpet inside the spare wheel. Jack points are allocated under the arrows on the sill.
To reconnect the door handle on a 1997 Fiat Bravo, first, remove the interior door panel by unscrewing any fasteners and gently prying it off to access the mechanism. Locate the connecting rod or cable that links the door handle to the latch mechanism. Reattach the rod or cable to the handle and ensure it is secured properly, then test the handle's movement before reassembling the door panel. Finally, replace the panel and fasteners, ensuring everything is snug and correctly aligned.
Fiat owns Fiat