0
What else can I help you with?
What size laminated timber beam is needed for a 23 foot clear span under a 15 foot roof in between load bearing walls?
38 feet longIt is not possible to give a definite answer without more detail. The construction and type of roof will determine the load (weight) bearing on the beam, and factors such as wind load and earthquake load, and the way the roof bears on the beam (truss/point load/distributed load) will all affect the sizing.
What size laminated timber beam is needed for a 23 foot clear span under a 15 foot roof in between load bearing walls -?
38 feet longIt is not possible to give a definite answer without more detail. The construction and type of roof will determine the load (weight) bearing on the beam, and factors such as wind load and earthquake load, and the way the roof bears on the beam (truss/point load/distributed load) will all affect the sizing.
What is a carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
What is carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
How is paper laminated?
Paper is laminated by covering it with a thin layer of plastic film. This film is then heated and pressure is applied to bond it securely to the paper, creating a protective coating that makes the paper more durable and resistant to damage. Once cooled, the laminated paper can be trimmed to size if needed.
Can outer race and inner race of bearing rotation relatively?
No. Either the inner, or outer, at least one race, has to be a press fit, otherwise it is no longer a bearing that is needed. A bushing would work. With both races turning you eliminate the bearing.
Why is a ball bearing needed for the transmission in a 1986 Chevy s10?
If it is a standard transmission S10 maybe they are talking about the "throwout bearing" which is part of the clutch operation that can go bad.
What tools are needed to change a wheel bearing?
Bearing needs to be pressed old out and new pressed in. Cost about $40 to have it removed from auto shop. But you can install it by chilling (freezer) the replacement bearing overnight and then heat the hub (200 oven don't want to melt the inner bearing seal) and drive the new bearing in with a soft hammer or wood block. Don't forget the bearing seals innerfirst before the bearing and then outer after bearing is in. Best to remove hub and do it on a bench.
How do you remove the rear inner wheel bearing on a '74 VW Type 1?
More information needed, and need memory refreshed. Do you mean the bearing that is mounted on the rear axle assembly, the CV joint bearing, or the bearing in the transmission. As I recall, Type 1 is a VW bug. Please verify.
What size socket is needed to remove the rear hub bearing nut on a 2000 dodge stratus?
30mm
Could a collision occur when the distance decreases and bearing between to vessels increases?
Yes, a collision could still occur in this scenario if the vessels are on intersecting courses despite the increasing bearing angle. It's important to consider the changing distances between vessels along with their course and speed to determine the risk of collision. Staying vigilant and taking evasive action if needed is crucial to prevent accidents.
What are the tools and procedures needed to replace a front drive wheel bearing on a 97 Chevy Cavalier?
Make darn sure it isn't the tire first. Take the strut off, and have the bearing pressed.
