To change the oil in a Honda Rubicon 500, first, warm up the engine to thin the oil, then turn it off and let it cool slightly. Place a drain pan under the oil drain plug, remove the plug, and allow the old oil to fully drain. Replace the drain plug, then remove the oil filter and install a new one, ensuring the rubber gasket is lubricated. Finally, refill the engine with the appropriate type and amount of oil through the dipstick tube and check the level to ensure it's correct.
10w40
hold the odo and the button right underneath it at the same time for 2 sec.
Just over 5 quarts.
15412-KEA-003
The 2006 Rubicon holds 4.9 qts when you change it. It is for both the engine and transmission.
This vehicle takes 2.3 quarts If It has the manual shirt transmission.
10w40
sitting on it, it would be under the cover with three bolts on it on the bottom right side of the motor
a size 12 mm for the drain plug. and a size 17 for the oil filter housing.
4.9 quarts when if you change the filter too...4.7 if you don't
4.9 quarts
About 5 quarts