0
What else can I help you with?
How do you set the timing on a 1985 Honda fourtrax 250?
To set the timing on a 1985 Honda FourTrax 250, first ensure the engine is at top dead center (TDC) on the compression stroke. Remove the timing inspection plug to check the timing marks on the flywheel; align the mark with the index mark on the engine case. Adjust the ignition timing by loosening the stator screws and rotating it until the mark aligns correctly, then tighten the screws. Finally, recheck the timing to ensure it remains aligned after securing the stator.
How much did a 1985 Honda fourtrax 250 cost new?
A 1985 Honda fourtrax 250 cost $ 2150.00 brand new. I bought one in June of '85
Will a 1985 stator work in a 1987 Honda spree?
Yes.
What kind and weight of oil is best for a 1985 1200a goldwing?
I use Motul 10w40. Good for the engine, clutch and stator. Check with your Honda dealer.
How do you adjust the timing on a 1985 Honda fourtrax ATV?
To adjust the timing on a 1985 Honda FourTrax ATV, first, ensure the engine is at top dead center (TDC) on the compression stroke. Then, locate the timing mark on the flywheel and align it with the pointer on the engine case. Adjust the timing by loosening the mounting bolts on the ignition coil or stator and rotating it slightly as needed to achieve the proper alignment. Finally, tighten the bolts and recheck the timing to ensure it's set correctly.
How much is a 1985 fourtrax 250 Honda ATV worth?
Depending on the shape.. I would say about $500 Joe
How good is the 1985 Honda fourtrax 250 ATV?
old school you could take that bike through anything
Is a 1985 Honda fourtrax 250 starter reduction gears compatible with an 86 or 87 Honda fourtrax 250 starter reduction gears?
The starter reduction gears from a 1985 Honda FourTrax 250 are generally not compatible with the 1986 or 1987 models due to differences in design and specifications. While the overall engine and transmission may appear similar, manufacturers often make subtle revisions that can affect part compatibility. It's best to consult a parts manual or a dealership to confirm compatibility before making any replacements.
How do you check stator on a 1985 75hp mercury outboard?
To check the stator on a 1985 75hp Mercury outboard, first, disconnect the battery and remove the flywheel to access the stator. Use a multimeter to measure the resistance between the stator's terminals; refer to the service manual for the specific resistance values. Additionally, inspect for any signs of physical damage or corrosion. If the readings are outside the specified range or if you find damage, the stator may need to be replaced.
Do 1985 Honda fourtrax have clutch cable?
Yes, the 1985 Honda FourTrax models, such as the TRX125 and TRX200, are equipped with a clutch cable. This cable connects the clutch lever to the clutch mechanism, allowing the rider to engage and disengage the clutch for shifting gears. However, the specific configuration may vary depending on the model, so it's essential to refer to the owner's manual for detailed information.
What is the capacity and viscosity of oil for a 1985 Honda Fourtrax 250?
AnySE /SF rated10w30 or 10w40 (4 stroke motorcycle oil preferred). Holds about 2 litres...
Where is the Timing mark on a 1985 Honda fourtrax fourwheeler?
On a 1985 Honda FourTrax, the timing mark is typically located on the flywheel or the engine's timing cover. You may need to remove the left side engine cover to access the flywheel. The timing mark is usually a notch or a line on the flywheel, which aligns with a corresponding mark on the engine case to set the timing correctly. Always refer to the service manual for specific details and procedures.
