You press the button on the left hand brake that has an red R on it then you down shift.
To put a 2011 Honda Rancher 420 in reverse, first ensure the ATV is at a complete stop. Then, locate the reverse override switch, typically found on the left handlebar; press and hold it. While holding the switch, shift the gear lever to the reverse position, which is often marked with an "R." Release the switch, and you are now in reverse.
push the red button on left brake lever before pulling it back, once the lever is pulled then pucs the bottom shift button and it will drop outta neutral into reverse.
While stationary and in neautral there is a red button on the left handlebar on the rear brake lever. You need to push this down and pull the brake lever and then you can push the foot gear selector down for reverse.
will a 300 honda motor fit a 350 honda rancher
cut it use jb weld to put back together in half
on the left hand grip is a red button push it in and apply the left brake,push your foot shifter down and you will be in reverse.
Put two moth balls inside a FULL tank of gas. Also helps to clean out carb and injectors.
420% = 4.2 = 21/5
theres a little red button on the left handle bar push that down then pull that brake lever in and shift down untill it goes into reverse
yes , get a small clear fuel filter and run it just below the pecock valve. mine works fine after 4 years
Seek professional help as your reverse gear is defective.
You simply push the red R button down on the left brake handle pull brake in and hit the down shift button and your in reverse... hope this helps ...C.M.