0
What else can I help you with?
How do you remove engine stack pulley on Murray riding lawn mower?
remove the mowing deck this should be very simple just a few pins. then in th ebottom of the stack pulley shaft is a bolt you will need a deep well 5/8" socket to reach up inside the shaft remove the bolt and the pulley should slide down and off.
Why does the mowing belt jump off on a 42 Murray riding mower?
Belt is stretched or the tension pulley
Why is your craftsman riding mower not moving?
1) The drive belt could be broken. 2) The rearend could be bad 3) The brake on the rearend could be stuck. (this would make the rear tires lock up) 4) The pulley on the engine or rearend could be the problem. You need to do a little investigating to see what is going on where.
How do you remove the drive pulley off the shaft of a GT262 riding mower?
Use a puller so you do not bend the pulley.
How do you remove the governor on a Murray riding mower?
I need to know how to remove a bolt from a pulley assembly on a Briggs and Stratton 8 hp vertical lawn mower engine. It seems to be rusty. I tied DW40 and vise grips and shaft slips. Any suggestions?
Pulley diagrams for Murray riding lawn mowers?
Not quite sure of the question, but I will give you a site I did (no ads, no nothing) and see if it helps:
How do you remove rear drive pulley on Huskee riding lawn mower with it on mower?
To remove the rear drive pulley from a Huskee riding lawn mower while it's still on the mower, first ensure the mower is turned off and the battery is disconnected for safety. Remove the belt from the pulley by loosening the tensioner if necessary. Then, use a socket wrench to remove the bolts securing the pulley to the shaft. If the pulley is stuck, gently tap it with a rubber mallet to help loosen it.
How do you determine if you have a bad pulley on a riding lawn mower?
Remove the belt(s) and manipulate the pulley by hand; its action should be butter-smooth.
how to install main drive belt on Murray riding mower?
To install the main drive belt on a Murray riding mower, first ensure the mower is turned off and the key is removed for safety. Remove the mower deck by disconnecting the belt and any necessary bolts. Next, route the new drive belt around the engine pulley and axle pulley, following the mower's belt routing diagram, which is usually found on the mower's frame. Finally, reattach the deck and check the tension on the belt before starting the mower.
Which direction do you turn to remove the blades on a Murray riding mower?
Most lawnmowers loosen to the left. At least that's how I do it.
How do you tighten a drive belt on Lowes MTD Riding Tractor?
remove the varable speed pulley-replace both belts re-install varable speed pulley--your done.
Where can you find a manual for a 1984 42 Murray riding mower?
A Murray riding lawnmower owners manual can be obtained from most Murray riding lawnmower dealerships. You can find the owners manual at most local libraries.
