0
What else can I help you with?
How do you remove stater selinoid on kawasaki mule 550?
How do you remove the starter selinoid on a kawasaki mule 550, 2000 model
Wiring Diagram For Kawasaki Mule 550?
The wiring diagram, of a Kawasaki Mule, 550, can be obtained from most Kawasaki dealerships. The wiring diagram can be purchased at most auto-parts stores.
Adjusting governor to get more speed on 550 kawasaki mule?
You can adjust the governor, on your 550 Kawasaki Mule, by increasing the fuel to the carburetor. The fuel adjustment screw is on top of the governor.
Where is the fuse box located on a kawasaki 550 mule?
It's under the seat
Twhere is the engine oil drain plug on a kawasaki 550 mule?
passenger side of engine.
What type of engine oil does a kawasaki mule 550 use?
The manual says to use 10w40. 1.3 liters w/ filter change. 1.1 without.
Why won't the kawasaki mule 550 start even with a new battery?
it might be the Neutral safety switch
What is the napa filter replacement for a kawasaki mule 550?
It's a Napa Gold 1394 or Napa Power Sport PS1394
What is the fork oil capacity on kawasaki 550 zephyr?
461 cc from empty( forks stripped)
How to release the brake adjustment to remove the rear brake drum on a kawasaki mule 550?
Yeah I'm having same problem did you ever fugure it out?
How do you set parking brake on kawasaki mule 550?
To set the parking brake on a Kawasaki Mule 550, first ensure the vehicle is in a stationary position. Pull up the parking brake lever, located between the driver's seat and the center console, until it is fully engaged. You should hear a click indicating that the brake is locked in place. Always check that the brake is securely set before leaving the vehicle.
How do you change the neutral safety switch on kawasaki 550 mule?
To change the neutral safety switch on a Kawasaki 550 Mule, first, disconnect the battery to ensure safety. Locate the neutral safety switch, typically found near the transmission or on the shift lever assembly. Remove the wiring connectors and any mounting screws to detach the old switch. Install the new switch, reconnect the wiring, and reattach any fasteners before reconnecting the battery and testing the operation.
