On a Kawasaki Mule 610, the oil filter is typically located on the engine, near the oil pan. To access it, you may need to lift the seat or remove the panel covering the engine compartment. Always refer to the owner's manual for specific details and maintenance instructions.
The recommended type of oil to use for a Kawasaki 610 Mule is API SF. Th610 Mule will hold approximately 1.5 quarts of oil.
NAPA 1394 Hi Flo 128 Fram PH 4967
I have a 2007 Mule 4x4 610 and the oil capacity is 1.5 U.S. quarts. (1.4 L.)
The oil dipstick, on your Kawasaki Mule 610, can be found on the right side of the engine. The top to the oil dipstick should be colored black.
The Kawasaki 610 holds 1.5 US qt in a completely dry engine. You should never overfill the motor oil. You can check the motor oil with the motor oil dipstick. 1.37 Qt if changing oil and and removing filter. 1.1 us qt if your not removing filter. this is straight from the Kawasaki mule dealer mechanic guide. and on a normal oil change with filter removed its barley over 1 QT.
20w 50
There is not a pressure switch however there is a temp warning sensor on the back of the crankcase in the bottom
An oil change should be done according to mileage and not necessarily time changes. You can give the Kawasaki Mule 610 an oil change after every 10,000 kilometers.
The oil capacity for a Kawasaki Mule 3010 is 1.5 L, (1.6 US QTS. when filter is not removed)1.8 L when filter is removed. The oil levels should be between F & L lines on dipstick.
The oil drain plug, on a Kawasaki Mule Model 2510, is on the bottom of the oil pan. The oil pan is on the lawless part of the engine.
could it be pressure on tank due to unvented gas cap? try running with vented cap.
on the engine......stupid.