To pitch of roof, place a one foot level on the roof with one side touching, and the other side in the air (leveled) from the side in the air, measure down in inches. If you measure 5 inches, then your roof has a 5/12 pitch; meaning it rises five feet of height in every twelve feet of run.
Using this number and a little math you can figure the height of roof ridge, measure total width, divide by two to find one half. If your roof pitch was 5/12 and you measured the half measurement to center of 14 feet, then your height to the ridge (off the top of end wall of house) is 5.83 feet.
This number is found by dividing your pitch numbers; 5 divided by 12, and then multiply that number by 14.
10 FT Many zoning by laws refer to the max allowable height of a structure as being the height from the finished grade to a point representing the "average height" of the roof. If you have a typical gable roof you essentially need to determine the average height of a triangle. You will often hear that it is the mid point, but that is not correct. Depending on the method / logic you use (basic algebra or calculus) the resulting formula for the average height of a triangle results in ... 0.2929 X h or 1/3 h Where h is the distance from the base of the triangle to the max height.
Some factors that determine is diet & exercise. The more calcium you eat, the better chance you have of being tall.
By using a metric tape measure
with the roof vent cover - - -mine is almost 9' hi
A woman's period does not affect her height. Her height is affected by the genetics of her family which will determine how tall she grows.
I would consider the roofline the highest point, or the "ridge".
The apex of roof is basically the highest point of the roof where ridge cap and ridge roll of a roof is located.
With the available information, you cannot. You also need the pitch or the height of the roof above the height of the enclosure.
To seal the ridge from weather. If a ridge vent is used it is just that, a vent for the roof.
The highest part of the roof is the ridge.
The highest point of each roof area.
Sometimes its looks over function that determine the roof pitch. Are the mechanicals in the attic or the basement? What part of the country, snow/rain load. Sometimes the span will determine how high the ridge ends up. Sometimes the cost comes into play.
peak or ridge or ridge cap
The top of the house had a ridge on it.Our house has a ridge on the top of the roof.
Ridge
The highest point, the peak of each gable or hip.
For a typical gable roof you have a ridge board at the top with rafters running from the ridge to the top plates of the walls