answersLogoWhite

0


Best Answer

the front side markers should have a screw on the outside if it does then remove that then open the hood and look for a little peice of plastic that is connected to the sidemarker then just pull it out torwards the front of the car. if it doesnt have a screw then it should just have one when you open the hood and then just pull it out straight forward.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the marker light on a 93 Toyota Corolla?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Movies & Television

Why do your running lights front marker and rear marker and tail lights and dash lights and plate light stay on after the car is off key is out light switch is off 1999 Toyota Corolla ve?

Because the lights were turned on manually instead of letting the automatic headlight illumination circuitry do its own thing. Turn the switch to "OFF" - it's part of the turn indicator arm.


How do you replace side marker light Xterra?

On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.


What is the problem if the blinkers flashers and headlights stopped working in a 1986 Toyota Corolla?

Sounds like an electrical problem, check your battery, alternator, and fuse box, and light wiring.


What causes a 1994 Toyota corolla tail lights to work but not any of the brake lights?

usually it is a fault with the brake light switch located on the brake pedal arm. there is a plastic button that sometimes disintegrates and no longer allows contact with the switch. Check that first. You can find a replacement by using a body fastener.


How do you replace the turn signal and marker light on a 2004 Chevy Corvette?

My left signal light went two days ago. This is what I had to do. Pull the carpet down Remove all the screws that hold the tail light on You will probably need pliers or a wrench to get out the bulb holder Auto Zone helped me and it used a 3157 sylvania bulb when the manual said to find a 3357. I guess they are interchangeable. Good luck.