0
Any specific device that draws a current which is connected within the circuit is an example of a circuit load. That may be a resistance and a loudspeaker LED computer and induction motor or whatever which can withdraw the energy from the output.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Are no load and short circuit similar?
No. No load and short circuit is not similar. No load can be 1) Either open circuit i.e. Only Potential is available and load is not connected 2) Load (i.e. motor etc ) is connected but not working with full load or full capacity. In this case the current will flow through the circuit depending on the load. It means No load condition is a condition where no current or a small ( relative / comparative term) current is flowing through the circuit. In Short circuit the load side resistance/ impedance become so less that very high amount of current is passing through circuit.( The protection is therefor required for any circuit) No load and and short circuit is not similar. Thanks
What happens when the circuit is complete and the switches are closed?
*Look at the simple circuit illustrated in Figure A-2. What will happen when only switch S1 is closed? Correct Answer= "Nothing will happen-the light bulb won't light up." <<>> If there is a load in the circuit the load will operate. If there is no load in the circuit and it is complete then a short circuit will occur and something in the circuit will burn open. If the circuit is complete and there is a fuse or breaker in the circuit, then the fuse or breaker will open the circuit.
Where is the most energy used in a circuit?
The most energy used in a circuit is at the load.
What is the kind of circuit in which an electrical load may be disconnected without affecting other loads?
In a parallel circuit an electrical load may be disconnected without affecting other loads.
In a circuit with resistive and inductive load what happens to the power factor as the resistive load increases?
The PF will increase
What is a circuit with no load?
An open circuit or a short-circuit (if that circuit is complete).
What is the load of a circuit?
The load of a flashlight is the bulb.
What is a motor in a circuit?
A motor in a circuit is classed as the circuit's load.
A circuit with a separate path for each appliance is a?
A circuit with a separate path for each load is a dedicated circuit. <<>> A circuit with a separate path for each load is a parallel circuit.
Are no load and short circuit similar?
No. No load and short circuit is not similar. No load can be 1) Either open circuit i.e. Only Potential is available and load is not connected 2) Load (i.e. motor etc ) is connected but not working with full load or full capacity. In this case the current will flow through the circuit depending on the load. It means No load condition is a condition where no current or a small ( relative / comparative term) current is flowing through the circuit. In Short circuit the load side resistance/ impedance become so less that very high amount of current is passing through circuit.( The protection is therefor required for any circuit) No load and and short circuit is not similar. Thanks
What does a load do to the flow of electrical current in a series circuit?
A load increases the flow of electrical current in a series circuit. No load, no flow.
What is open circuit voltage when load is connected?
As load is conected in circuit , so thre is no open circuit therefore there would not be any open circuit voltage.
What is a bulb's job in a circuit?
The bulb is the load of the circuit, without it you have a short circuit.
What is positive controlled circuit?
this is a circuit in which the switch is located before the load in the circuit
What does the work in an electric circuit?
The load that is connected in a circuit is what does the work in the circuit.
What are the kind of circuit?
the electrical circuit, load, conductor, open circuit, switch,
How to figure out ampreage in a circuit?
For a d.c. circuit, you divide its supply voltage by the resistance of its load. For an a.c. circuit, you divide its supply voltage by the impedance of its load.
