The reason for conducting transormer turns ratio is to determine if the transformer is a step-up or step-down.
AnswerTo determine the turns ratio if the turns ratio is unknown.
'Tappings' are externally-accessible electrical connections to the turns of a transformer's (usually high-voltage) winding. This enables the number of turns to be changed, resulting in a change to the transformer's turns ratio and, therefore, to its voltage ratio. Tap changing enables the electricity network company to adjust the turns ratio in response to any excessive voltage reduction resulting from a heavy load.
plz give me answer the above question
The primary current on a loaded transformer depends on the secondary current, which is determined by the load. So, if you know the secondary load current, then you can use the turns ratio of the transformer to determine the primary current:Ip/Is = Ns/Np
If the line impedance is Z0 and the load is ZL then connect the load using a transformer with N turns ration. N=sqrt(Z0/ZL)
Transformers come in very many varieties and voltages. Transformers have ratings regarding the electrical power that they are connected to. The most important ratings are voltage, power and current. In general the insulation level and number of windings in the secondary and primary determine the maximum rated voltage, and the size of the magnetic wire that makes up the windings, and mass of the iron core, determines the rated power and rated current. It is the insulation level therefore, that determines the maximum, safe voltage that can occur on both the secondary side and the primary side. The turns ratio between the primary and secondary coils of the transformer determines the secondary voltage with respect to the primary voltage. If the primary coil has 1000 turns, and the secondary coil has 100 turns, the transformer turns ratio (usually designated by the letter "a") is 100 / 1000 = 0.1. If a = 0.1, then if 1000 volts are applied across the primary coil, ideally, 100 volts will be measured across the secondary. Transformers have been manufactured with secondary voltage ratings in the range of millivolts, to 1,000,000 volts.
For an ideal transformer, the voltage ratio is the same as its turns ratio.
Transformer ratio, more correctly turns ratio, is the number of turns in the primary winding divided by the number of turns in the secondary winding.
Transformer turns ratio is the ratio of voltages between two windings. For instance, a 24VAC control transformer that runs on 120VAC will have a turns ratio about 5 to 1.
A transformer primary of 1200 turns with a secondary of 400 turns is a ratio of 3 to 1.
Transformer turns ratio
It's approximately the inverse of the voltage- or turns-ratio:
with an ideal electrical transformer with an input current of 2 amps and an output current of 1 amp what is the turns ratio of the secondary and primary coils
TTR = Transformer Turns Ratio
It depends on the turns ratio of the transformer.
The turns ratio is the number of primary turns divided by the number of secondary turns. This is the same ratio as input current to output current. ie the turns ratio N = I1/I2
ratio of secondry voltage to primary voltage is called voltage transformation ratio
I think you mean 'turns' rather than 'coils' (a coil is made up of a number of turns). The answer is that, yes, the turns ratio is the same as the voltage ratio, for an ideal transformer.