You can repair your wired headset that has a bad connection at any electronic store near you. No u can't I've tried
bad connection from the battery or alternator
"A wiring fault" which - depending on the actual behavior of the bad connection - might also be described as "an intermittent fault", "a high resistance fault", or a combination of all three terms. For example: "An intermittent, high resistance wiring fault".
You need to buy a PS2 Network Adapter as well as a Ps2 wireless internet connector (lookup: linksys) other than that I don't think you can just connect to your own wireless...... not a bad idea though.
The switch could be bad. There could be a loose connection on the fuse box, or on the rear of the instrument cluster.
You need to have a scanner. The ones that the repair shops use are far superior to the ones at the parts houses. The parts houses are there to sell parts. The repair shop is there to Repair the problem. Just because you get a code say for an oxygen sensor does NOT mean that it is bad. Something as small as a vacuum leak can cause the code. The parts house sells you the sensor you do NOT need and the repair shop repairs the vacuum leak and you keep your oxygen sensor.
If your router keeps shutting off and rebooting, when you try and access WiFi, it sounds like your router is bad. Another sign the router is bad is your ability to use a wired connection without a problem.
Since your router is in the same room purchase an ethernet cable and have a wired connection. This improved the internet connection speed on the PS3 connection test for my PS3. The wired connection may solve your problems and will let you confirm that the problem is not with the connection to the router. Ethernet cables are inexpensive, but purchase a name brand cable. A Cat 6 Ethernet cable will work perfect even though it is really for higher speeds than the Cat 5 ethernet cable.
Are you sure the light bulb is good? Perhaps it's not wired correctly even though you think it is, or maybe it's a bad light socket/connection, or a bad switch.
The clutch is wired with a hot from the battery at all times and requires a ground from the switch to engage. Check for a bad ground wire to the clutch or a bad ground connection.
The Sony Playstation Stereo headset for $80 (Amazon) is designed to work with the PS3 and is not a bad choice among the available products
You need to clean the connection where the ground is faulty. Start at the battery. Take off the cable wire brush the battery and cable then spray with some white lithium grease to prevent futher problems.
There are a few reasons for a Jeep error code 121. Some of the causes are a bad connection with the TPS, a corroded sensor, or a harness is rubbing a harness.
There are many possible reasons which you can investigate. Can be bad headset, bad or loose connector jack in the laptop, bad SW driver for the sound hardware, interference/undesired mixing from other sources. To find the real reason, you can try out different things like, is the sound OK when you connect external speakers instead of headset. Is it bad with only one headset or you have tried different headsets. Try reinstalling the sound drivers. Disable/mute all the other sound sources (like mic input). Try various audio files. These will help you find the root cause of the problem - Neeraj Sharma
A headset is a device, which enables a person to talk on mobile phones via an extended set of ear plugs. This protects a person against the bad radiations produced by a cellphone.
It lags with slow connection , bad connection or corrupted connection
Get a faster Internet connection.
Low or bad battery. Bad connections on battery posts. No connection through the ignition switch to the starter relay. Relay defective. Cables loose. Starter bad. A simple voltmeter is very helpful on these repair problems.