to turn electrical potential into mechanical work/motion.
Any specific device that draws a current which is connected within the circuit is an example of a circuit load. That may be a resistance and a loudspeaker LED computer and induction motor or whatever which can withdraw the energy from the output.
Yes, just reverse the start winding circuit.
The part that opens the circuit is the overload blocks that are situated below the magnetic starter and before the motor load. The latest addition to the electrical code book states that the "hot" wire goes through the overload contacts first before feeding the 3 wire control system. With the supply voltage in this position the whole circuit becomes de-energized when the motor load trips the circuit. The old standard practice on a 3 wire control system, the neutral was connected to the overload relay contacts. When the overload relay tripped it opened the neutral of the coil circuit and the starter dropped out
A closed series circuit is one where the current flows through all devices in the circuit. Opening a switch prevents current from flowing in the circuit and it becomes simply an "open circuit". Any device that operates with current (light, LED, motor, etc) will no longer function.
no, but you do need a power source, such as a cell or a power pack if you do not want to use a battery.
I HAVE A SMALL ELECTRIC CLOCK MOTOR THAT I NEED TO REVERSE. WHAT IS THE CIRCUIT I NEED TO REVERSE IT?
The circuit breaker is sized to the full load amps of the motor times 250%.
A motor in a circuit is classed as the circuit's load.
Cannot answer this question. Will need to know the voltage and amperage of the circuit. Also need to know the application i.e. is it a lighting circuit or a motor circuit?
A motor is not needed in a circuit, a motor is an electrical load for the current to drive, but the circuit can perform with other types of load - such as a lamp, a transformer, a heating coil, or any electronic load. if you mean 'why does an electric motor need a circuit?' this is because the motor is an electrical device which has coils of wire to produce a magnetic field, without the circuit it cannot function.
In the circuit where the DC motor is added, it was not specified whether the motor was added in series or in parallel to circuit elements. If it was added in series, it will increase circuit resistance and it will cause circuit current to go down. In parallel, the motor will reduce total circuit resistance, and circuit current will increase.
In dc motor we need a complete kit of motor driving circuit whereas in af we only need a starter
u need a power source (battery, mains etc) and 1 or more components (bulb, motor etc)
if the the motor is good you need to check the circuit breaker because the circuit breaker might be the problem. window doesnt go bad my dude the motor goes bad check it again
A three phase motor control circuit.
If the circuit was open, the tram's motor could not run!
there is small circuit board mounted on wiper motor. Circuit board available at Chevy Dealers or IWI motor parts. No need to remove motor but micro stubby screw drivers needed to remove and replace. worked great.