yeah but ur gone need a power amp too
He uses a lot of different ones. There is no specific amp he always uses. But some of what he has used includes: Mesa Boogie Triple Rectifier amp head Marshall JCM 900 amp head Mesa Boogie 2:90 power amp Triaxis preamp Marshall EL34 power amp JMP-1 preamp
A preamp intensifies the signal being received.
it could be to bias the tubes, depends if the knop is in the preamp or poweramp sections (you dont need to bias preamp tubes)
A guitar preamp is basically a guitar amplifier, but without the power amplifier section that drives the speaker. A typical guitar amplifier consists of two components: the preamp and the power amp. The preamp is responsible for generating most of the characteristics of the guitar tone. The power amp receives the output signal from the preamp, then raises it's level enough to drive a speaker so the guitar becomes audible. Physically, a guitar preamp can be an independent rack-mountable unit, a digital device (such as a Line6 POD), a floor pedal, or even circuitry inside the guitar itself.
Send and return on a guitar amp refers to an effects loop that allows you to integrate external effects processors between the preamp and power amp sections. The "send" jack sends the signal from the preamp out to the effects unit, while the "return" jack brings the processed signal back into the amp before it reaches the power section. This setup preserves the tonal integrity of the guitar signal and allows for greater flexibility in effects placement, particularly for time-based effects like reverb and delay.
He uses a lot of different ones. There is no specific amp he always uses. But some of what he has used includes: Mesa Boogie Triple Rectifier amp head Marshall JCM 900 amp head Mesa Boogie 2:90 power amp Triaxis preamp Marshall EL34 power amp JMP-1 preamp
An amp head is a component of a guitar amplifier that contains the power and preamp sections. It is used to amplify the signal from an electric guitar or other musical instrument before sending it to the speaker cabinet for sound output.
NO preamp has wattage or a wattage rating. The only wattage involved in a sound system comes from the POWER amp
A preamp intensifies the signal being received.
To safely plug a bass into a guitar amp, use a direct box or a bass preamp to match the impedance levels, and avoid turning the volume too high to prevent damage to the amp and speakers.
it could be to bias the tubes, depends if the knop is in the preamp or poweramp sections (you dont need to bias preamp tubes)
I would not advise this, because of the difference of impedence.
Connect your recording device to the preamp output on the back.
A guitar preamp is basically a guitar amplifier, but without the power amplifier section that drives the speaker. A typical guitar amplifier consists of two components: the preamp and the power amp. The preamp is responsible for generating most of the characteristics of the guitar tone. The power amp receives the output signal from the preamp, then raises it's level enough to drive a speaker so the guitar becomes audible. Physically, a guitar preamp can be an independent rack-mountable unit, a digital device (such as a Line6 POD), a floor pedal, or even circuitry inside the guitar itself.
To test the output of an acoustic guitar preamp you may use output tubes to test. This will test the preamp voltage.
Audio out (line out) from the Home Theater to audio in (line in) on the Power Amp. If you use Preamp out on the Home Theater the Volume Control will control the volume of the Power Amp and Speakers.
The best way to amplify an electric guitar using an acoustic amp is to use a preamp pedal designed for electric guitars. This will help match the tone and characteristics of the electric guitar to the acoustic amp, resulting in a better sound quality.