It would be helpful to know what kind of problems you're having and the kind of vehicle its on including make, model, year.
If your low beams are not working or if one is not it may just be that you have a bad bulb. Usually the high and low both come from the same bulb and its intirely possible that a low beam filament is burnt out but the high beam filiment isn't (typically the low beams are used way more than the high).
If this isn't the case then more info would be necessary in order to further diagnose the problem.
Good luck and we look forward to hearing from you again about this.
9005 low beam 9006 high beam 9011 HIR low beam 9012 HIR high beam HIR is not an HID bulb althought with no modification, it produces HID intensity without annoying another drivers... definetly something to look into
YES.....
== == more than likely your dimmer switch is bad,hope that will help
Start by removing the plastic protective cover by twisting to the right and pulling off. The low beam light is a small halogen light at the top of the two light clusters. The lower light is the high beam light (part 9005 typically). The low beam light goes into the light casing at the top under the funny dome like structure and is reflected backwards onto the light casing to create the low beam. It's a $12 part usually. One plug, one spring, no tools required for drivers side, 10MM socket to remove airscoop intake on passenger side in order to get to light cover.
my name is hi-low, piccolo, piccalo hi low hi lo piccalo piccalo no name
9006x for the low beam and 9005x for the high beam.
9006 for the low beam 9005 for the high beam
High beam light is out!
You Have a bad headlight, it's common when a headlight burns out for only the high beam to work, solution change your headlight.
9006 for low beam and 9005 for high beam
The headlight has two filaments. One for the high beam and one for the low beam. The most likely reason the high beam is out is because the high beam filament is broken. Replace the bulb and it should fix it.
There are two headlight relays, high beam (C1005),low beam (C1006).There are four headlight fuses,Left low beam (F16) 10 amp,Right low beam (F17) 10 amp,Left high beam (F26) 10 amp,Right high beam (F27) 10 amp.
The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.
According to the OWNERS MANUALS,1995-1998:LH headlight - low beam - #4RH headlight - low beam - #10Both headlights - high beam - #38Engine compartment fuse panel - "K"1999-2003Note: these fuses are in the fusebox in the ENGINE COMPARTMENT.RH headlight - high & low - #9LH headlight - high & low - #12See "Related Questions" below for more
9005 high beam and 9006 low beam.
H11B Low beam. H1 High beam.
Burnt out or loosely connected bulb.