you have to remove the wood grain trim peice by just pulling then remove the air vents there are about 7 screws under the wood trim and then another 1 under each vent then open the glove box to get to 2 more screws then remove it once you remove all the screws the dash should lift right out
located in back window with rear defog
installdr.com
To remove the radio faceplate of an Eclipse 54400, start by gently prying off the trim bezel using a plastic removal tool or your fingers to avoid damaging the dashboard. Once the bezel is removed, locate the screws securing the faceplate and unscrew them. Carefully detach the faceplate by pulling it away from the main unit, ensuring you do not damage any connectors. Finally, disconnect any wiring harnesses if needed.
I found the easiest way to do remove the woodgrain faceplate is to take a small scewdriver, and bend the end of it until it is hooked shaped, then put the hook behind the faceplate one corner at a time, slowly pulling out until each corner pops loose. Its the best way I know how, I have took many off this way with no damage to the faceplate.
Yest, the Buick LeSabre from 1992-1994 is the same exact car, inside, outside, underside. Everything is identical, except say for the trim packages and options you get on them. Therefore, yes the cassette radio from a 1992 LeSabre will work in a 1994 LeSabre.
remove the screws and give it a slight tug
1995 Buick LeSabre how do i reset my radio
Remove the decorative radio retaining plate. Remove the retaining screws. Pull the radio out. Remove the wiring harness. Remove the antenna cable.
To remove the radio from a 1992 Buick LeSabre, first disconnect the negative battery cable to ensure safety. Then, carefully pry off the trim panel surrounding the radio using a flathead screwdriver or a trim removal tool. Remove the screws securing the radio in place, then gently pull the radio out of the dashboard and disconnect the wiring harness and antenna cable from the back. Once the connections are removed, the radio can be fully detached.
located in back window with rear defog
Remove the dashboard faceplate, and the rest is pretty simple.
fuse #44 behind left side of dash
use the removal tools in the holes on the sides of faceplate
installdr.com
yesgo to walmart and buy a plug kit
When the radio was installed in the 1993 Le Sabre, something was bumped or disconnected. You will have to remove the radio then check the system to see what the problem is.
Very easy. Pull faceplate cowling off, pinch together plastic pins on outside of radio and pull whole radio out.