answersLogoWhite

0

First, remove the NEGATIVE battery terminal from the battery.

Remove the two black screws at the bottom of the decorative panel beneath the steering wheel column. Remove the panel.

Remove the two black screws at the top of the metal shield beneath the steering column and remove the shield.

In the center of the dash, remove the trim panel around the radio and controls by pulling first at the bottom of the trim, carefully. Remove the top of the panel and remove the panel. There are clips at the top and bottom. Sometimes they stick or bend and may require a fair bit of force.

Remove the four black screws securing the right side of the dash trim panel. This will completely uncover the center outlet grills and the radio.

Pop the clips loose on the left side of the panel. Lower the steering column to its full down position. Remove the trim panel from around the headlight knob and remove the trim panel.

There are two screws on each side of the instrument cluster. Remove these. Carefully wiggle the cluster while pulling on it and it will come loose from the two connectors that plug into the rear side of it.

Reinstall by reversing the procedure being careful to align the two connectors on the rear and seating the cluster. Do Not Force. It should seat flush on the seats and not require the screws to do anything other than hold it in place. I personally recommend a shot of WD40 on the connectors before plugging the cluster back into the dash.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Music & Radio

2000 jeep Cherokee 4L it has electronic ododmeter but lamp had turned off somehowso you cannot read miles on it is there any fuse that controls it needs to be replaced?

The most likely cause is a faulty connection at the back of the instrument panel. Remove the panel assembly and clean the wiring connector contacts.


How do you change 1999 Jeep Cherokee's window regulator and motor?

Remove doop panel, remove dust cover, remove two nuts holding window, unbolt guide post, unbolt motor, swing assembly thru openning


How do you change the windshield washer switch on a 1997 Jeep Cherokee?

In order to change the washer pump on a 97 Jeep Cherokee Sport you must remove the grill assembly and then the driver's side front quarter panel. Once the quarter panel is removed you can see the washer fluid reervoir and the pumps fit into the reservoir. The majority of the work is in getting the quarter panel off. The front quarter panel is attached with screws and bolts located at the front (under the grill assembly), at the back (the door must be open to reach these), and on the top and bottom (including around the wheel well). I recently replaced mine and then a week later the replacement pump went out, bummer.


Where is FUSE FOR WINDOWS and DOOR LOCKS ON JEEP CHEROKEE SPORT?

In the fuse center located behind the passenger side kick panel for a 1997-2001 Jeep Sport you will find the fuse/circuit breaker for the power windows and power door locks located in position number 28.


How do you remove the inside door panel of a 2000 Jeep Cherokee Sport to replace the window motor After removing the screws the panel does not budge?

That is a good answer. I would add a cautionery note that the snaps are flimsy and break easily. It it is the same as my 2001 Grand Cherokee there are plastic snaps along the perimeter of the door trim. You will neet to us a putty knife to start prying it away to snap the trim off. The best place to start is the bottom left corner and work your way around. Answer Go to this site for a detailed answer: http://www.wjjeeps.com/doors/doorpanel.htm

Related Questions

Why is there no communication between the computer and the scanner on a Jeep Cherokee 1998 sport?

the CCD bus in the instrument panel is bad


How can you remove the instrument panel on your 1995 Jeep Grand Cherokee because a bulb is out?

Go to this website wjjeeps.com


How do you take the instrument panel out of a 08 Tahoe?

Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.


How do you remove the inside rear hatch panel to access a broken lock in a 1998 Cherokee Sport when the door is closed?

To remove the inside rear hatch panel of a 1998 Cherokee Sport with the door closed, you’ll need to carefully pry off the plastic trim pieces surrounding the panel. Use a flat tool or a trim removal tool to avoid damaging the clips. Once the trim is off, look for screws securing the panel and remove them. After detaching the panel from the clips, gently pull it away to access the lock mechanism.


How do you change dash lights in 2001 intrepid?

remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights


Instrument panel removal Ford Expedition?

How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine


How do you remove the door panel for a 2003 Montero Sport?

how do you remove the door panel for a 2003 mitisbushi montero


How do you remove instrument panel 87 Mazda b2000?

To remove the instrument panel on a 1987 Mazda B2000, start by disconnecting the negative battery cable to ensure safety. Remove any screws securing the trim bezel around the instrument panel, then carefully pry it off using a trim tool. Next, unscrew the instrument panel itself and disconnect the wiring harnesses at the back. Once everything is detached, you can lift out the instrument panel for replacement or repair.


How do you replace the dash speakers in a 1998 Chrysler Cirrus?

Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.


How to remove instrument panel on a Skoda octavia 2007?

To remove the instrument panel on a 2007 Skoda Octavia, first, disconnect the car battery to ensure safety. Then, carefully remove the trim surrounding the instrument cluster using a trim removal tool to avoid damaging the dashboard. Unscrew the screws securing the instrument panel, typically located at the top and sides, and gently pull the panel out. Finally, disconnect any electrical connectors before fully removing the instrument panel.


How do you change a Chevy S-10 instrument panel light?

remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.


How do you remove an instrument panel on a 98 Mitsubishi eclipse?

To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.