I just did this today. 1. remove the 3 plastic screws below glovebox. 2. remove plastic screw farther down under dash (after you do above, you will know what I'm talking about. 3. remove panel (all screws should be out now) 4. go behind dash and remove two nuts that hold radio in place. 5. push on radio from behind, and radio will come out the front. 6. Detach all connectors (about 8).
PS: I removed the negative battery cable just to make sure the power is off.
If you do it right, you can get it out in 1/2 hour without damaging your dash. Don't believe the people who tell you you have to take your dash out. The only panel that needs to be removed is the one below the glovebox, and it's pretty easy to do that without breaking anything.
! Steve
Attached in the links below are diagrams for the factory radio and the related dash panels to remove it. I've also posted some additional links for future reference.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
as long as it is the factory radio, go to your nearest Mazda dealer and they should be able to get the code using your VIN number. good luck
Begin by removing the decorative cover from your 2001 Pontiac Bonneville radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
look on top of the radio there is a tray. grab the top of the tray and pull out there are clips that hold it together then just let it hang from the wires you will see the radio on brackets then just remove the 4 bolts from the bracket and pull the radio out dont forget to remove the conncetions on the back. once you remove the radio there are 4 screws on each side of the radio that is holding the radio to the bracket. remove those to remove radio from bracket. dont lose those screws your going to need them to install on new radio. any more questions e-mail emezahth@gmail.com
how do i remove the starter motor Mazda rx8
NO, they have a harness for it on eBay though for 50 to 75 dollars
Just use your brain
The 2011 version of the Mazda RX8 was the last model produced by Mazda. Models of the Mazda RX8 are still available for purchase and can be found online.
WE CAN GET MAZDA RX8 IN GTA SAN ANDREAS By installing rx8 mod
change the body style of it which is like a thousand something dollars
wher can you find the chassis number of mazda rx8
Rx8, but not by too much.
how good were they Nazda RX8 2004
Nope.
remove the two 10mm nuts. dissconnnect the coolant level sensor plug and remove coolant hose's
No, the RX8 does not have camshafts, therefore it does not require a timing belt.