brake hose's are about $20 each , steel lines can be replaced in sections for about $5 a section
It is made into the liquid line, you have to replace the line to service.
Start by removing the connections for the cruise control and brake lights, then remove the bolt that holds the switch to the brake pedal. Once the brake pedal is loose the switch is held on the brake pushrod by a bushing with nylon retaining washers. Carefully remove one washer and slide the bushing out, the switch can now be removed from the pushrod. Installation is the reverse; line up the hole on the switch with the hole on the pushrod, make sure the tabs for the cruise control and brake lights are facing properly. Reinstall the bushing and replace the other nylon washer, replace the bolt and tighten. Lastly connect the brake lights and cruise control.
You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.
In line on the heater hoses on the passenger side of the engine. Has a small vacuum line to it and both heater hoses go through it. The heater hoses are smaller than the radiator hoses and go through the firwall.
Flatblade screwdriver. Would likely be easier if you moved the power steering pump, but its possible without doing that too.
How do i replace brake lines on a 2000 grand am
vacuum leak at the master cylinder or vacuum line to the master cylinder
measure affected line
Length of back brake line to replace. hole in it between front and back door
Replace the brake line, bleed the brake. top up with brake fluid. Done.
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
replace brake line the damage to the line or if the jb weld gets into the line it will affect how the system works.
Remove the line and replace it. Then make sure to keep the master cylinder full while you & a helper bleed the front brake caliber. Be sure and use brake line tools and not open-end wrenches or you will damage the brake lines.
replace the line and fill and bleed breaks.
replace brake line
Replace and bleed line
In-line 6 firing order1 5 3 6 2 4 I need to know the wire order for a 1997 jeep Cherokee sport