What is it you want to know about the radio?
answer
I assume , you want to replace the radio in your sedona. follow the steps below.
Lift the Kia's hood and loosen the bolt holding the negative battery cable to the battery terminal with the wrench. Lift the cable from the battery and set it away from the terminals. Move to the inside of the car.
Pry the dash panel surrounding the gear selector lever away from the dashboard with the trim panel removal tool. Set the panel aside. Remove the two screws at the bottom of the stereo assembly dash panel with the Phillips-head screwdriver.
Remove the trim panel surrounding the stereo assembly from the dashboard by hand. Set the panel aside. Remove the four screws around the perimeter of the factory stereo with the screwdriver.
Slide the stereo from the dashboard stereo dock. Unplug the stereo wiring and antenna cable from the back of the unit. Plug the stereo wiring connectors into the plastic end connectors of the wiring harness adapter.
Insert the installation cage into the Kia's stereo dock. Fold the cage's metal tabs outward with the flat screwdriver. Pull the wiring harness adapter and antenna cable from the back of the dock, through the cage to the front of the dash.
Plug the wiring harness adapter leads into the outlets on the rear panel of the new stereo. Plug the antenna cable lead into the antenna input on the back of the aftermarket unit. Slide the stereo into the cage until it snaps into place within the stereo dock.
Place the larger of the two removed dash panels onto the dashboard around the stereo assembly. Press against the panel to snap it into place. Replace the two screws at the bottom of the panel with the Phillips-head screwdriver.
Place the remaining dash panel onto the dashboard below the stereo. Press against the panel to snap it back into place on the dashboard. Return to the Kia's engine compartment.
Place the battery cable's clamp back onto the negative battery terminal. Tighten the bolt on the cable's clamp with the wrench. Close the hood.
try googling it, otherwise you have to take radio out, get serial number off it and visit your local Kia dealer and they can look it up for you.
There is no exact way to reset a Kia Sorrento radio using a code. Codes can be revealed at the car dealership providing you prove ownership of the car. The radio code is tied to the VIN number.
Radio was released on 10/24/2003.
Your Radio was created on 2003-11-30.
Radio Radio TV Sleep was created on 2003-08-25.
The 2003 Kia Sedona has 24 valves.
The 2003 Kia Sedona has a V6 engine.
The 2003 Kia Sedona is a gas-powered vehicle.
The 2003 Kia Sedona has a 5-speed automatic.
The maximum payload of the 2003 Kia Sedona is 1186 lbs..
The 2003 Kia Sedona's turning circle is 41 ft..
The height of the 2003 Kia Sedona is 5 ft. 9.3 in. (69.3 in.).
The 2003 Kia Sedona is 16 ft. 2.1 in. (194.1 in.) long.
The curb weight of the 2003 Kia Sedona is 4802 lbs..
The 2003 Kia Sedona runs on regular unleaded.
The 2003 Kia Sedona has double overhead cam (DOHC).
The 2003 Kia Sedona has 58.7 in. of front hip room.