answersLogoWhite

0

What else can I help you with?

Related Questions

What causes a 98 Malibu to make a clunking noise that can be felt in the brake when shifting from reverse to drive and upon acceleration from a dead or slow stop?

This could be the breaks needing replaced, could be a wheel bearing that needs replaced.


Why would a car stall shifting from park to reverse?

A car might stall when shifting from park to reverse if the idle is set too low. It is also possible that the engine stalls because it is not fully warmed up before shifting from park to reverse.


The car stahls when shifting into drive or reverse?

Drive...


Why does 95 ford crown Victoria make a clank noise when shifting into drive or reverse?

Have your u-joints checked on the drive shaft. Most likely need to be replaced. If that's not it, then check the slack in the diff.


Who replaced Mika in falling in reverse?

Ron Ficarro has replaced Mika


Your 3000gt sl drives forward but when down shifting its hard to go in 4th and when you go in reverse it pops out could that be your shifting fork?

yes


What causes erratic idle when shifting to reverse?

might be bad motor mount / or electrical short


Why would your transmission have problems shifting in 1 or 2 and reverse but only at times?

bad filter


Why would a 2001 Hyundai Sonata reverse lights stay on and only turn off when shifting into reverse?

Sounds like the reverse switch is either damaged, or wired backwards... Did you have your clutch done recently?


Why does your 1989 Bronco II clunk when shifting and grind when engaged in first and reverse?

bad synco rings


1997 dodge neon it wont shift from 3rd to reverse?

i cannot shift from 3 to reverse my cable line for the shifting is disconnected and don't know where it suppose to go


What causes a clicking and popping sound on a Silverado when shifting into reverse then shifting into drive and taking off?

well it could be the transmission bracket or ur motor mounts but im not real sure