The correct torque spec is 85 INCH lbs.
the 4.0 six in a 90 jeep Cherokee is not a v6 it is an inline 6. the firing order is 153624
The bleeding sequence is back right,back left,front right,front left works on the later 98's to 2004 jeep grand cherokees
Look for the answer online at autozone ,under repair info.
The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.
You can read the answer for Set-Up your Jeep VIC in this forum post: http://www.jeepsunlimited.com/forums/showthread.php?t=800167 Good luck!!!
tightening sequence of what part?
bolt tightening sequence on what part?
48 hole bolt tightening seqence
Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83
No such thing, just remove them. However there is a sequence to tightening them.
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
head bolt sequence Toyota tercel
Rover 20T2N 2.0Ltr Diesel engine Cam cover torques are listed as 12 Nm. No tightening sequence is listed .
that depends on the motor that it has.
Engineers.
The tightening sequence for the head bolts on a Peugeot 106 1.1 is to begin at 1 and of the head. Move to the opposite end of the head. Alternate back in forth until you reached the middle.