Wiki User
∙ 2009-04-09 16:40:29Answer -Clean throttle body/Carb cleaner There is an idle sensor within the Throttle Body which becomes dirty from carbon. Two things: Add a can of that Carb cleaner to a tank of gas, I know it's not supposed to have a carb but it works and second, try spraying a cleaner, they have a spray cleaner in auto store for this purpose, directly down the throttle body, under the bonnet and wipe as well as you can with a rag, working it in as far as you can. Once the sensor is clean, the stalling will stop. ya my car was dying and i replaced the idle air control valve, really easy to replace just was $140, or go to wrecking yard. you could also try your TPS. if it dies at any other time other than idling it wont be the idle air control valve. there is a few ways to test them. i never tried it but i heard start your car and then unplug the data/electricity line and if your car keeps running then its a bad unit, if it dies then its good. dont start replacing sh*t unless you know for sure you dont have a vacuum leak!!
Wiki User
∙ 2009-04-09 16:40:29Check under dash at your brake pedal for a plunger sensor, the brake pedal may not let it be releasing. Brake pedal arm pushes it in to activate the lights
Perform service on a 2004 Jeep comes on when it is time for an oil change.
I can answer for the 93 Jeep Grand Cherokee Limited. There are three 10mm nuts holding the lens on. Remove these nuts and the light sockets are twist and putt to gain access to the lights.
Where is the 1994 JEEP grand cherokee Daytime Running Lamps Lights Module? Lights are working but the running lights and dash board lights are out.
All of my 93 to 98 gc's do that, it's called a courtesy feature.
There are many places where one could purchase a Jeep Grand Cherokee limited edition car. One could try online shops such as Amazon or eBay for deals on this brand of vehicle.
In the oil pan
The fog lights on a 2004 Jeep Grand Cherokee are accessed from the wheel wells. Remove the rivets for the dust covers to gain access to the lights. Twist off the bulbs and replace them.
pull it out of the box to bypass the centrifuge
Try your Dodge/Jeep dealer first
Check under dash at your brake pedal for a plunger sensor, the brake pedal may not let it be releasing. Brake pedal arm pushes it in to activate the lights
I would say the jeep is faster.
The only foolproof way is to remove the starter and bench test it.
I had the same problem with my 1997 Grand Cherokee and it was the dash mounted automatic light switch. The problem was also solved by turning the headlamps on manually.
where is the ac drain on 1999 jeep grand cherokee limited
Perform service on a 2004 Jeep comes on when it is time for an oil change.
Using a very clean small plastic funnel pour it down the transmission dipstick tube.