How ic 741 works?
Transmitting over four watts on a CB radio is actually illegal, thus, using a linear amp on a CB is illegal, as well. A linear amp attached to a radio (for argument's sake, we'll assume it's on a type of radio on which the application is legal) simply amplifies the power output. The radio transmits into the amp, the amp amplifies the signal, and transmits it to the antenna.
It may be under the drivers seat as on the lucida. If changing radio to standard you need to bypass the amp unit and wire radio to speakers direct. This means connecting all speaker wires to the ones that go from the old radio to amp unit. You will need to make a note of all connections as you do them all one by one. Tricky if your not experienced with wiring.
I had the same problem and found that the subwoofer amplifier was apparently defective. Unplugged tha amp and everything works OK now. Amp is behind cover in right rear of vehicle. Amp can be unplugged by removing cup holder. Jim Jim, You are the man! I did exactly what you wrote and the radio works. Thanks! Scott
10 amp... in socket # 20
if you are using an aftermarket wiring harness hook up the remote turn on wire on the new radio it should be blue with a white stripe to the harness also has a blue and white stripe and plug it in this wire turns on the factory amplifier if you are not using a harness you will have to locate the internal amplifier wire of the radio and connect that to the remote turn on on the aftermarket radio = answer = the inernal apm power wire is white on the black wire harness ANSWER if you dont want to use the factory amp. just run new speaker wires to each speaker.
Yes an Op-amp
Try changing your fuses 25 amp
Transmitting over four watts on a CB radio is actually illegal, thus, using a linear amp on a CB is illegal, as well. A linear amp attached to a radio (for argument's sake, we'll assume it's on a type of radio on which the application is legal) simply amplifies the power output. The radio transmits into the amp, the amp amplifies the signal, and transmits it to the antenna.
where the bmw radio amp located
black
It may be under the drivers seat as on the lucida. If changing radio to standard you need to bypass the amp unit and wire radio to speakers direct. This means connecting all speaker wires to the ones that go from the old radio to amp unit. You will need to make a note of all connections as you do them all one by one. Tricky if your not experienced with wiring.
If it was working fine and then just stopped working then it's probably the amp that is in the trunk on a tray under the package shelf. If it is the amp, only the ones from 93 to 94 will work.
Yellow Wire.
bypass the factory amp
The fuse for the radio in a 2000 Dodge Avenger is 10 amp.
how do you go around amp for after market radio on 1995 ford probe
if you dont have the speaker on the passenger side hooked up and you still are using the radio that is your problem. When the radio sends out the electical pulses to the speaker and there is no speaker there fot the current to go the current will then go back to the radio and fry the amp. You could blow the amp out of your radio if you dont hook up antother speaker to the wires. You can change the balance setting on your radio and move it totally to the driver side. you will lose the speaker in the back on the passenger side but you will have fixed the problem.