answersLogoWhite

0

the fuel system might have air in the lines from running dry. try leaving the key in the ON position without trying to start it for a while which should let the electric fuel pump push fuel into the lines. then try to start the car. dont hold the starter on for more that 5-10 seconds in a half minute frame due to the danger of burning up your starter motor. if the engine starts, great! if not, keep reading.

try looking for blown fuses!

it may have trash in the fuel filter which can be blocking the flow of fuel. when you run out of gas in a vehicle that old, all the trash that has accumulated over the years can enter the fuel line, and cause blockage, and even stalling. if you replace the filter and it fixes the problem, then good. again, if not, keep on reading!

you may need to drain the tank and clean the screen on the pickup of the electric fuel pump. it is accesible by lifting up the rear seat cushon and pulling away the felt. please be smart when working with fuel tanks and gasoline! if you clean the screen and it helps, then great! i have a few more tricks if it doesnt, but you must email me for them.

modular_trash08@yahool.com

1987 325is

User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Natural Sciences

What is the common names for Ice crank and crystal?

"Ice crank" is a common street name for crystal methamphetamine. "Crystal" is another common name for the drug as well.


How do you in install magnet on crank?

To install a magnet on a crank, you can use an adhesive or epoxy to secure the magnet to the crank arm. Make sure the surface is clean and dry before attaching the magnet. Ensure that the magnet is positioned correctly to align with the sensor for accurate readings.


How many crank amps required for chev 350 1998?

For a Chevy 350 engine from 1998, a typical recommendation is around 700-800 crank amps for reliable starting performance. It's important to consider factors like climate, engine condition, and any additional electrical components when choosing the appropriate crank amp rating for your specific vehicle.


How do you derestrict a 50cc piaggio typhoon carb?

Have u had a go at derestricting the restricter in the crank case ? All you do is take off the crank case and there should be a flywheel on the left u undo that flywheel and there should be a washer or spacer take that out and refit your flywheel and crank case making sure everything is tight :)


How many pounds can you lift with a 28 inch crank type handle turning an 8 inch round cylinder attached by a rope with a force of 50 foot pounds?

The question was going along so nicely there, until it got to the very end, and thenshot itself in the foot with "foot pounds"."Foot pounds" is a torque, not a force.-- If you apply 50 pounds of force at the end of the crank, that 50 pounds becomes175 pounds of force at the surface of the 8-inch cylinder, because the mechanicaladvantage of the crank/cylinder arrangement is 28/8 = 3.5 .-- If you apply 50 foot-pounds of torque at the end of the crank, then the force is50 ft-lb/28 inches = 50 lb x 12 in/28 in = 21 3/7 pounds .Now, the same mechanical advantage of 3.5 gives you 75 pounds at the hub.What a difference a unit makes !

Related Questions

Where is the mech crank on poptropica after you left like go to another island?

in your bag there is a mech crank in it


How can you stop a pregnancy a day or two after you have missed your period?

Stick a stick up there, crank it around until you have a thick creamy substance then drain....


What does the slang term crank mean?

The slang term "crank" is another word for the illegal drug meth ampetamine.


How do you remove the door crank on a Kia Sephia?

From reading some other posts in another chain , "you push the panel in and remove the clip on the crank..


Where is crank position sensor on 1988 Mazda b2200?

The part your inquiring about is not on your year model or engine.Unless I missed something it was offered only on the rx7 and 3.0 liter engines for 1988.Easy.


Where is the crank shaft position sensor located on a 2000 Mitsubishi Eclipse?

behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on


What is the common names for Ice crank and crystal?

"Ice crank" is a common street name for crystal methamphetamine. "Crystal" is another common name for the drug as well.


97 maxima crank up but wont start?

If a 1997 Nissan Maxima will crank but will not start, there could be a problem with the fuel pump. Another possibility is an issue with the ignition switch.


Why does a 1997 ford escort not start when jumped by another car?

If you mean it won't crank then the starter is defective. If you mean it will crank but not start it isn't getting fuel, spark or compression.


Is it normal to have weight added to the front of a 1991 350 crank to get it balanced?

the harmonic balancer, is the pulley on the front of the crankshaft. this is used to balance a crankshaft.


What is crank and slotted quick return mechanism?

A crank and slotted quick return mechanism is a mechanism that has a slotted lever attached to another lever and a wheel. These types of mechanism are frequently found in shaping machines.


Would a three piece crank for a touring bike work?

There's something missing from this question. If you are asking about translanting a crank from one bike to another, then the answer is "maybe". There are several different versions available, and not all can be interchanged.