If you have a bad plug on a lamp cord, also called zip cord by some old timers, you can go to the hardware store and buy a replacement. Cut off the old plug and follow instructions for installing the new plug.
If you have a frayed or broken wire, you are better off buying a new cord, or if length isn't a problem, cut off the bad part and install a new plug on the remaining wire.
If you are dealing with a simple extension cord, your are usually better off economically and from a safety standpoint to just buy a new cord and disposing of the old cord. If the cord is hardwired into an appliance the techniques described.
Appliances cords are made of stranded wire because it is more flexible and less likely to break than solid wire. The multiple strands of wire in a stranded conductor also make it more resistant to fatigue and bending, which is important for a cord that may be moved and adjusted frequently.
Most lamp wire is parallel #16 conductors.
In a two-wire extension cord, the marked wire is typically the neutral wire, while the unmarked wire is the hot wire. The neutral wire carries current away from the device and is connected to the ground at the breaker panel, providing a return path. However, it's essential to confirm the correct wiring by checking the cord's specifications or using a multimeter, as different cords may have variations in marking conventions. Always ensure proper safety measures when working with electrical devices.
For a 30 watt mixer, you would typically need a wire size of at least 18 AWG (American Wire Gauge) for power cords and connections. This wire size can safely handle the current draw of a 30 watt device without overheating. It's always recommended to check the manufacturer's specifications for the mixer to ensure you are using the correct wire size.
If you are talking about electric extension cords they come in a variety of colours. Black, blue, yellow, red, and orange to name a few. Usually the colour is associated with a particular manufacturer.For more detailed information about the colors of the wiring inside the cords, see the answer to the Related question shown below.
All are wires firmly seated? Did wires get crossed upon installation? Defective wire? Defective plug? WRONG Plugs?
Mark and remove plug wires. Remove spark plugs and install new plugs. Reattach plug wire to correct plug.
Possible vacuum leak or defective plug wire.
Defective spark plug? Defective plug wire?
Appliances cords are made of stranded wire because it is more flexible and less likely to break than solid wire. The multiple strands of wire in a stranded conductor also make it more resistant to fatigue and bending, which is important for a cord that may be moved and adjusted frequently.
You need to know the current to determine the wire gauge.
Provides a way to keep cords organized
electrical = broken / rubbed wire. or defective pump. plumbing = broken pipe or bad check valve. either way you are hiring a plumber to correct problem.
You could have an ignition problem, such as defective spark plug wire or distributor cap or if it's an older car you might not have resistor spark plugs. I have also seen cars with defective alternators do this, as you rev the engine the noise seems to go to a higher frequency.
Most lamp wire is parallel #16 conductors.
earth
what about them?