answersLogoWhite

0


Best Answer

All are wires firmly seated? Did wires get crossed upon installation? Defective wire? Defective plug? WRONG Plugs?

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: You changed the plugs and wires on your 1991 subaru legacy wagon and now the car stalls out when you put it in gear and has a rough idle Please help what could it be It ran fine before?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

You have a 1996 Lincoln town car that runs great but stalls often you have changed the air flow valve and computer water sensor What else could you change to correct this please help?

Try a MAP sensor


Pontiac sunbird stalls in gear but idles just fine?

Mine did this and I found out it was the timing belt that needed to be changed.


2000 gmc jimmy engine stalls while driving?

One reason that a 2000 GMC Jimmy engine stalls while driving could be your filter needing to be changed. The problem could also be a bad sensor.


Your 1994 ford ranger stalls while driving you have replaced the fuel filter and spark plugs?

yes and no did not changed fuel filter


What is the collective noun for stalls?

There is no specific collective noun for stalls, in which case a collective noun suitable for the circumstances is used, for example a row of stalls, a group of stalls, a bank of stalls.


1994 Chevy lumina apv sometime stalls when put in gear help?

First what motor is in the van? Than tell me what it does before it stalls or you put it in gear. There many different possiables that it could be.


What are Sarabat stalls?

In Singapore, Sarabat Stalls are stalls selling drinks particularly milk tea


You have changed O2 and Camshaft Sensor but it stil stalls when RPM goes down when braking mostly What is there to fix?

vaccuum leak? maybe , just a theory


Ford E-250 van backfires and stalls?

You have bad spark plugs and they need to be changed or there could be a bad vacuum line that needs to be replaced.


99 grandprix gtp supercharge Car stalls lose rpm gage already changed mass air flow sensor what could be wrong?

try checking the IAC motor. if it stalls at idle then it could be that. or the egr valve. one of the two have to be contributing to the problem


97 sebring loses power and stalls at low speed?

There could be a few reasons why a 1997 Chrysler Sebring loses power and stalls at a low speed. The thermostat could be bad, the battery cables could be lose, or a spark plug may need changed.


My 2000 Ford Festiva stalls when its come to a stop in drive the rev's fall low and the car shudders before the engine completely stalls transmissions just been replaced what might be causing it?

Mine did that, it was the fuel pump!