You'll need two pieces of wire... and im pretty sure that if you take one end of the wire and put it on the very bottom of the light bulb and the other end of the wire and put it on the positive side of the battery, and take the other wire and put it on the threads of the light bulb and the other end of the wire and put that end on the negative side of the battery, you should get light. (I may have the polarities [positive & negative] mixed up).
A group of ten (10) batteries composed of 6 Volt and 12 Volt types will have six (6) each, 6 Volt and four (4) each 12 Volt batteries. The contributing voltages will be 6x6 and 12x4 for a total of 84 Volts.
It can vary depending on the model, but typically lawnmower batteries are 12 volts. It's important to check the specifications of your specific lawnmower model to ensure you purchase the correct battery.
No. A 12 v battery will actually have a charged peak voltage of 13.54v or 13.58v. A six volt charger will have around a max 7.5v voltage. The 6v charger will think the battery has peaked and will discontinue charging.
A D cell battery has a voltage output of 1.5 volts, while a 9 volt battery produces about 9 volts. This is just the potential energy though. D cells provide far more current for a longer time then a 9 volt battery. In terms of overall power output, a D cell in give you many times more power than a 9 volt battery. Physical size, in this case is a good indicator as the material inside is the same.
If the charger is a 12 volt DC machine, connect the leads to the two battery terminals that the load is taken from. Take care to note the polarity of the leads to the polarity of the battery terminals. There will be a short jumper cable between the two six volt batteries. The charger leads go on the opposite terminals of the two batteries that the jumper is connected to.
Is a eletromagnet with a six volt lantern battery really powerful or not?
You don't say what you are connecting to the battery. If you have a black and white wire the best guess would be white to negative terminal and black to positive terminal. If you were connecting a 6V light bulb it really doesn't matter.
A 12 volt automotive battery has six cells.
Buying a six volt battery is better than 12 volt. If you buy the 6 volt takes up less power so it holds more.
No! You need fewer cells for six volts. Most 9 volt batteries have six 1.5 volt cells, but a six volt battery has four 1.5 volt cells. In theory you could open the battery up and install a tap at the fourth cell, but that is pretty hard to do.
It depends on how the two six volt batteries are connected. If they are in parallel then the answer is no. If they are connected in series then the answer is yes. To find out for sure check the voltage that the starter needs. If it says 12 VDC then you will know that the two six volt batteries are wires in series and can be replaced with a 12 VDC battery.
Six volt batteries are available from websites like Battery Mart, Amazon, and eBay, or from retail stores like Kmart, Walmart, Home Depot, and Lowe's.
connect the 2 six-volt batteries together one terminal each positive to negitive, this will make a 12-volt combination, then you can connect the jumper cables, one side to the 12-volt battery and one side to the two 6-volt terminals, + & -
yes you do
AnswerAccording to WikiPedia (http:/en.wikipedia.org/wiki/Rechargeable_battery), the nominal cell voltage of a Lead Acid wet-cell battery is 2.1 volts, this implies there are 6 cells in a 12 volt Lead Acid wet-cell battery.
The first thing you need to know is if the truck is still the original six volt system or not. The charger is still hooked pos to pos, neg to neg regardless of whether it is pos or neg ground. Do not use a twelve volt charger on a six volt battery.
The PP3 battery, commonly known as a 9-volt battery, is not a single voltaic cell. It consists of six smaller 1.5-volt cells connected in series to provide a total of 9 volts.