I know for my grand am, I have to leave my key in the ignition for 15 minutes.
To reset the security system on a 2001 Saturn, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Then, turn the ignition off and attempt to start the engine. If the issue persists, consult the owner's manual or a professional for further assistance.
Yes. Simply turn on the ceiling fan while the light switch is in the "on" position. Adjust the spinning to the level of your choice. Now the fan will turn on and off when you switch the light on and off.
No, when it's off it's off. A very small and insignificant amount is wasted when you turn the light on.
"If it's not in use, turn off the juice!" is an example of an energy-saving slogan.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
how do you turn off security light on 1989 Buick Rhetta
To reset the security light on a Pontiac Alero, start by inserting the key into the ignition and turning it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Then, turn the key back to the "Off" position, wait a few seconds, and turn it to "On" again. This should reset the security system and turn off the light.
To reset the security light on a 2001 Pontiac Firebird, first ensure that you have the correct key that corresponds to your vehicle's security system. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off, then turn the key to the "Off" position and back to "On" again. This should reset the security system and turn off the light.
When your security light comes on and your car will not start, turn you key to the on position and wait 10 minutes. The light will go off and you need to turn the key to the off position, then restart your car.
punch it out
smash it with an axe as fast as you can
To reset the security light on a 1991 Pontiac Firebird, first, ensure that the vehicle is in the "Run" position without starting the engine. Then, turn the ignition off and back to "Run" three times in quick succession. After the third cycle, leave the ignition in "Run" for a few seconds, then turn it off again. This should reset the security system and turn off the security light.
The security light will blink when either door, hatch, or hood is opened and will continue blinking until it is closed. Check all 4 switches for proper operation. If the bad switch is disconnected it should turn off the light. If the security light is on constantly instead of blinking that is to let you know that the alarm system is activated and should turn off after a few minutes.
turn the ignition switch on (all the lights in dash light up) but do not crank engine. leave on for half hour untill security light goes off. turn off ignition, wait 30 seconds then start engine.
is your security light flashing? turn the key on, leave on for 10 mins, turn key off let it sit for 2 mins, start car
find the button or ask how
turn the ignition off for 3 minutes