answersLogoWhite

0

OK IM NOT SURE YOU WORDED THIS RIGHT , BUT HERE IS WHAT I WOULD DO IF THE WIRES ARE CUT OFF AT THE CASE FROM YOUR STATER , PULL THE COVER OFF ON THE CASE, THERE YOU SHOULD BE ABLE TO SEE SOME OF THE WIRES LEFT. IF THERE PULLED LOOSE, CALL AROUND FOR USED BIKE PARTS IN THE YELLOW PAGES LOOK UNDER NEW AND USED BIKE PARTS SINCE YOUR BIKE IS AS OLD AS IT IS . BUT IF THERE ARE WIRES AVAILABLE YOU CAN SRINK WRAP TO TY NEW WIRES TO YOUR STATER , THIS WAY IT TAKES UP LESS ROOM . MATCH UP THE COLOR WIRES YOU HAVE THERE MAKE SURE YOU HAVE LONG ENOUGH WIRE TO ROUTE TO WARE YOU NEED TO GO TO REACH YOUR CDI.?

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you remove the stator?

On what model??? 1985 kdx200


Will a 1985 stator work in a 1987 Honda spree?

Yes.


Looking for 1985 Yamaha XT400 or XT550 stator and pick up?

call ricky stator @ 866 631 3837 he has a the best $ on any stators made and he also rebuilds.


What kind and weight of oil is best for a 1985 1200a goldwing?

I use Motul 10w40. Good for the engine, clutch and stator. Check with your Honda dealer.


How do you change the distributor cap wires for a 1985 camaro?

get a set of new plug wires for it that are pre-cut for the car and then replace 1 wire at a time.


Where to hook up the wires for a tach on a 1985 Chevrolet s10 blazer?

You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê


What are the green and purple wires in your car for?

IN MY 1985 Pontiac Fiero some purple feed the computer sensors and some green feed the marker and tail lights.YOUR CAR WILL BE DIFFERENT!Unless its a Pontiac Fiero


Where is the distributor cap on a 1985 Chevrolet Impala located?

It is at the rear of the engine and has the plug wires coming out of it.


What order do the spark plug wires go for a 1985 Chrysler New Yorker 22L Turbo?

1243


How do you take the motor out of a 1985 Chevy Impala?

cut all the hoses and wires and hook a chain to it and rip it out.


How do you set the timing on a 1985 ATC 250 sx?

To set the timing on a 1985 ATC 250 SX, first, remove the left side cover to access the ignition system. Use a timing light and align the timing mark on the flywheel with the designated mark on the stator at the specified RPM (usually around 1,500 RPM). Adjust the stator by loosening the screws and rotating it until the marks align, then tighten the screws securely. Reassemble the cover and test the engine to ensure proper timing.


What wires coming off the firewall connect to the alternator and starter on a 1985 Silverado truck?

about 2 wires with fusible links in them running from divers firewall to passenger side starter behind engine block.