A typical fence charger pulls between 0.1 to 1 amp, depending on the size and power of the unit. Low-powered models may use around 0.1 to 0.5 amps, while more powerful chargers can draw up to 1 amp or slightly more. The exact amperage can vary based on the charger’s design and its intended use, such as for livestock or wildlife Fencing. Always refer to the manufacturer's specifications for precise information.
On a 50 amp 3 phase connector, you can pull 50 amps per leg. This means that each of the three phases can carry up to 50 amps individually, resulting in a total capacity of 50 amps per leg.
A typical iron pulls around 9-12 amps when in use. It's important to check the specific amp requirement of your iron to ensure it matches the capacity of your electrical circuit.
Power(Watts) = I (Amps) x E(Voltage) PIE rule. so 1000 = I x 240. 1000/240 = 4.16667 amps.
To determine the amperage draw of a 5200 BTU heater, you can use the formula: Amps = BTUs / (Voltage x Efficiency). For example, if the heater operates at 120 volts and has an efficiency of about 100%, it would pull approximately 43.3 amps (5200 BTU / 120 volts). However, many small heaters operate at lower voltages (like 120V), so it's essential to check the specific heater's specifications for accurate amperage.
Using the equation Volts X Amps = Watts, you can take 3000 watts / Volts to get your answer: 3000W/240V = 12.5A or 3000W/120V = 25A So, at 240 volts you will use 12.5 amps for 3000 watts of power. Or at 120 volts you will use 25 watts.
Wrong question, it depends on the charger, not the golf cart.
At 120 volts it will pull 4.166 amps. At 240 volts it will pull 2.08 amps.
Aprox 12 amps.
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
at 230v it will use 5 to 6 amps
About 2.25 Amps.
10.92 Amp
On a 50 amp 3 phase connector, you can pull 50 amps per leg. This means that each of the three phases can carry up to 50 amps individually, resulting in a total capacity of 50 amps per leg.
This typically has to do with how many amps you can safely pull from the secondary of the transformer.
5
Seven amps pulls zero kilowatts . W = A x V. You need to state a voltage to multiply the amperage by to get watts. Then divide by 1000 to get kilowatts.
stake and steak . that is the answer . stake goes with fence pole and steak goes with meat .