75 m3 of natural gas.
Approximately 30,000 gallons of water is required to condense one ton of steam.
It takes about 23 gallons of water to produce one gallon of almond milk.
No. The unequal heating will produce breezes, and perhaps clouds and rain, but much more is required to produce a tornado.
The amount of heat removed during the process of steam condensing and then freezing into ice is calculated by adding the heat required to condense the steam and the heat required to freeze the resulting water. This is determined using the specific heat capacity and latent heat of vaporization/condensation for water.
To determine the heat lost, we need to calculate the heat required to cool the steam from 400 K to 273 K (its condensation point), then the heat required to change it from steam to liquid water, and finally the heat required to freeze the water into ice at 273 K. These steps involve the specific heat capacities of water and steam, latent heat of vaporization, and latent heat of fusion.
How much steam is required to produce 5 MW power in steam turbine?In fully condensing turbine we will need 20 TPH steam required to generate for 5MW
The amount of MMbtu required to produce one ton of steam can vary depending on the efficiency of the boiler and the pressure of the steam. On average, it takes about 10-12 MMbtu to produce one ton of steam at standard conditions.
It would take 1 ton of water to create 1 ton of steam.
It equals one kilpod.
Around 350 million tonnes.
On average, about 33 million BTUs of natural gas are required to produce a ton of ammonia. This amount can vary depending on the efficiency of the production process and the technology used.
3.5 ton steam
This steam cleaner does not use any electrical power.
It takes about 1.2 cubic meters of natural gas to produce 1 kilogram of LPG (liquefied petroleum gas). This conversion factor can vary depending on the efficiency of the production process and the composition of the natural gas.
Approximately 30,000 gallons of water is required to condense one ton of steam.
1 pound of water at sea level can produce approximately 26.8 cubic feet of steam.
The steam required for steam tracing is calculated on the basis of the amount of heat transfer that is required or the temperature that you want to maintain with the help of steam. It also depends on the pipe material through which the steam is passing,the condition of the steam that whether it is saturated or superheated etc. Overall heat transfer cofficient is calculated considering all the factors like fouling or scaling,inside and outside dia. , surface area etc. After calculating the amount of heat to be transferred, the requirement of rate of steam is calculated. Generally, Low pressure steam is used as it has got more latent/Sensible heat as compared to MP or Superheated steam.