0
What else can I help you with?
What makes a Ford 2.8L V6 running rough when engine is cold?
I have had similar problems. I would try replacing the air charge temperature sensor. If you still have trouble, try heating the sensor by taping it to a radiator or heater hose. If this fixes the problem, heated air from the shroud around the exhaust manifold is not reaching the air cleaner, causing the sensor to read to cold of a temperature and making the engine run too rich. Hope this helps.
I am having problems with my 89 Sahara passing emissions. does anyone know the common causes?
Common causes for emissions test failures in a 1989 Jeep Wrangler Sahara can include issues with the oxygen sensor, catalytic converter, spark plugs, or fuel injectors. It is also advisable to check for vacuum leaks, exhaust leaks, and ensure that the engine is properly tuned. Regular maintenance and addressing any malfunctioning components should help improve emission performance.
Where is the camshaft position sensor on a 1999 Saturn sl1?
The camshaft position sensor on a 1999 Saturn SL1 is typically located near the camshaft itself. It is often situated on the cylinder head or timing cover, close to where the camshaft rotates. Refer to your vehicle's specific service manual for the exact location.
How many watts does a motion sensor take?
A motion sensor typically consumes very little power, usually in the range of 0.5 to 2 watts, depending on the specific model and features it offers. This low power consumption allows motion sensors to operate efficiently and continuously without causing a significant increase in energy usage.
Is it true MPX10 or MPX12 the basic sensor is diaphragm?
Yes, both the MPX10 and MPX12 utilize a diaphragm as the basic sensing element. This diaphragm deflects with changes in pressure, causing corresponding changes in electrical output.
Is there problems passing emission on a 1988 volkswagen cabriolet?
Provided the catalytic converter, oxygen sensor and related components are good working order, no.
How much is it to fix a miss fire on 1996 Chevy Tahoe?
Tough question,untill you find out whats causing the miss to start with.Could be 1 of these problems making it miss. ( Bad spark plug, plug wire, Bad distributor cap, Injector problem, emission sensor shorted are grounded- O2 sensor / oxygen sensor, Map sensor, vacuum leak, Low engine compression / burnt Valve. ect....
Which oxygen sensor should you change on your 1999 Chevy blazer back firing problems?
If it had a bad O2 sensor the "check engine" would be illuminated and a code would be set indicating which sensor is at fault. You probably have other problems causing that backfire to occur.
What happens when the crank shaft sensor fails?
The ignition timing will be off causing misfiring among other problems.
What and where is a emission sensor on a 1998 Chevy Cavalier?
There are many sensors that could be called the emission sensor for this vehicle, but I suspect you might be referring to the oxygen or O2 sensor. It will be found in the exhaust manifold, close to the connection with the exhaust pipe. Hope this helps!
Where is the camshaft sensor on a C6 Corvette?
Not positive on C6 but on my 93, there was a front mount "optispark" ignition module which included a crank position sensor mounted straight on the front of the engine behind the crank pulley. They were vented and notorious for getting damp inside & causing problems since they were optical. At least that was the explanation I heard.
What is wrong when the Service engine soon light comes on?
Could be any number of things ... a short list: * low engine oil level * low cooland level * emission problems * spark plug or ignition problems * oxygen sensor defect You can take the car to most any auto parts house and have the "code" read for a small fee. That will tell you exactly what may be causing the problem.
What is the meaning of emission code po138?
O2 sensor circuit high voltage (bank 1 sensor 2)
What does PO452 EVAP Emission Control system pressure sensor low 99 chev 1500 5.7 emission test?
PO452 is the name of the error code you are receiving. The evaporative emission pressure sensor mount plug could be disconnected so that should solve the problem.
Where is emission parts on 1992 integra?
Emission parts contain a number of things such as; spark plugs/wire, O2 sensor, pcv valve, vapor canisters, MAP sensor idle control valve, etc
How do you disable 2007-2010 escalade speed sensor?
You cannot disable a vehicle speed sensor on any EFI vehicle without causing a host of problems. I'm not sure why anybody would want to.
What is an MAF sensor in a Hyundai santa fe and how much does it cost to fix?
MAF sensor is the Mass air flow sensor...with out it your engine doesnt think its getting enough air ..causing rough idle...no acceleration etc.. the average cost of the sensor is $156.00
