if there is no camshaft position sensor then why am i getting codes for it and how do i eliminate those codes?
On a 1999 Saturn, the ETC (Electronic Throttle Control) sensor is typically located on the throttle body, which is situated on the intake manifold. It is usually mounted directly to the throttle plate assembly and works in conjunction with the accelerator pedal position sensor to control the engine's throttle response. To access it, you may need to remove the air intake duct or other components depending on your specific model. Always refer to a service manual for detailed instructions.
The Saturn SL2 was produced from the years 1990 to 2002 in the United States. The best way to tell if the fusible link in a 1999 Saturn SL2 is fried is that there will be no 12v.
The 1999 Saturn SC is equipped with a 1.9-liter I4 engine. This engine is part of Saturn's S-Series and is known for its durability and fuel efficiency. It produces approximately 124 horsepower and is available with either a five-speed manual or a four-speed automatic transmission. Overall, the engine is designed for reliable everyday performance.
Yes, Perry Saturn has been located. After struggling with personal challenges, including homelessness, he was found and received support from the wrestling community and various organizations. Saturn has since been actively working on improving his well-being and life.
The axle nut on a 1999 Saturn SW2 typically requires a 32mm socket to remove. It's important to verify the size by checking the specific model and year of your vehicle, as sizes can vary. Make sure to use the correct tools to avoid damaging the nut or the surrounding components.
were is the camshaft position sensor on 1999 Volvo s80 turbo
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine
Camshaft position sensor circuit malfunction.Camshaft position sensor circuit malfunction.
how to remplace position of oxigen sensor
A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.
No.
where is bank 2 camshaft located audi a6 2.8 1999
Under the distributor cap.
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.