Yes it is different. I have a 2004 FLHTPI. The wiring harness for the FLHTPI is set up for the extra lights and accessory plugs for the additional equipment/electronics that the police bike is outfitted with. I tried to install the air temp and oil pressure gage in the dash and could not match the schematics on the installation instructions to the wiring harness. I had to bring it in to have the gages hooked up. I plan to add a stereo and will run into the same issue with the wiring harness. I haven't found any good resources on the internet regarding solutions yet.
Absolutely ... and you best do this before applying any electrical current to it - water is a conductor of electricity, and if it gets inside the wiring insulation, it could short out several wires causing a fire or other blown electrical or electronic components.
No, the electrical plug-ins for a 700R4 and a 4L60E transmission are not the same. While both transmissions are electronically controlled, they have different wiring harness connectors and pin configurations. It is important to use the correct wiring harness for each transmission to ensure proper function.
In Peugeot 206 vehicles, the standard wiring colors for the vehicle stereo are as follows: Yellow: Constant 12V+ Red: Switched 12V+ Black: Ground Blue: Remote control It's always recommended to use a wiring harness adapter to ensure proper connections and avoid damaging the vehicle's electrical system.
The ISO standard for electrical wiring in a road vehicle depends on the vehicle. The ISO's include 1185:2003, 1724:2003, and 3731:2003. The ICS standard is 29 and 31.
None.In standard single phase wiring there are 3 wires: hot (black), neutral (white), and ground (green). Each has a different purpose and none can be used for any other purpose.
A john Deere Dealer. The wiring harness comes in 3 different pieces. The last time I checked the three totaled about $1,000.00.
Standard 2 Piece Harness Up To Late 1990
No.....They look the same but they are not the same. The wires have been put in different places.
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
it will not work the wires and connectot are different
You can find an external wiring harness for a 1971 Evinrude 25 Hp outboard at different boating shops. You can also check with the manufacturer.
NO. The computer and the wireing harness is different and so is the fuel pump / pressure.
The wiring harness can be removed by unplugging all of the wires. The wiring harness is also held in place by several retaining screws. Remove the retaining screws.
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
It depends on which Harness you are looking for.
2006 Dodge Dakota - Where do i find the trailer wiring harness