Capacitive loads have a leading power factor. Current leads voltage when there is capacitive reactance. (The opposite is inductive, which is lagging.)
Capacitive reactance.
I would suggest first looking on the inside of the fuse box(s) cover, where it should show the location/purpose of each fuse. If not, reference the vehicles manual for the fuse that corelates to the lighter.
fuse
No, you should not use a 32V 15A fuse in an appliance that requires a 125V 15A fuse. The voltage rating of the fuse is important for safety, and using a lower voltage fuse can result in the fuse not providing adequate protection and potentially causing a safety hazard. Always use the recommended fuse rating for your appliance.
capacitive reaction
The capacitive reactance of a capacitor increases as the frequency decreases.
An IPS capacitive touchscreen is a type of technology that is used on LCD's.
A circuit that has only a capacitor in it. Or the net reactance is below zero, making it capacitive. The current leads the voltage in a negative (capacitive) reactive circuit.
In a purely capacitive circuit, the current and the components have a relationship where the current leads the voltage by 90 degrees. This means that the current and voltage are out of phase in a purely capacitive circuit.
yyiiiiii
no
No, inductive
It isn't necessarily so. The capacitive voltage is the product of the current and capacitive reactance, while the inductive voltage is the product of the current and the inductive reactance. So it depends whether the capacitive reactance is greater or smaller than the inductive reactance!
Because it is. Capacitive reactance is a form of resistance, along with inductive reactance. All are measured in ohms.
The capacitive reactance is approximately 4 kΩ .
Resistive touchscreens are better if you do not wish to use a stylus. When a stylus is used, capacitive touchscreens respond better. The decision on which is better comes from the applications being used and the preferences of the user.