Chevrolet

No. 2500 is a 3/4 ton. The HD signifies a heavy duty suspension, more like a one ton, or 3500. The HD has a largerr hood, and more aggressive grille, and metal radiator, verses a plastic.

The Corvair name originated as a show car in 1954, which, like many Chevrolet concept cars of the period. The design was championed by Ed Cole, Chevrolet's chief engineer in the early 1950s and general manager in the late 1950s, as an answer to the growing popularity of small, lightweight imported cars. The name Corvair is an offshoot of the name Corvette as was Camaro.

Start by checking the fuses.

u use a trans jack or if u want to go to a automatic they sale a conversion kit at autozone

The turn signal Flasher Relay is defective. Your turn signal relay is located Front seating area, driver side, passenger side of steering column, under dash, mounted near cigarette lighter. Optional mounting location is under dash, on driver side of steering column.

Yes the frames are the same although some extension adapters will have to be used so get them from the short box you are pulling from.

where is the cranksensor on 1994 chevy pickup with a 6.5 engine

internal means that parts havebin sanded or milled to the same diameter and external means the dampener or balancer

Either on the door or on the pillar drivers side.

Remove the wheel, caliper, and rotor (you may also have to remove the wheel bearings depending on the specific model). The wheel speed sensor is attached to the end of the wire facing the wheel hub.

I have one but cap and vaccuum advance are missing.

Lack of oil or it was damaged during installation. Was it pre-lubed before installing? If not, that is why it failed.

It's usually caused by improper break-in procedure, but can also be caused by burrs in the lifter bores preventing the lifters from revolving or improper break-in oil.

take two wrenches and break lose all the nuts then tighten one back up to break losse last one same to put back together

timing belts need to be changed every 60k miles

if its in good shape, no rust then about $5000 if its all rusty and messed up about $500 at most.

also if it runs or not

Open tailgate. You will find 2 screws that take a star tool. Take them out. Pull the tail light assemble out. Unplug the wiring harress. Remove the 2 screws that hold what looks like a curciut board. Separate the board from the lens. pull bad bulb out and replace with good one. reverse procedure to assemble.

year the 283 engine was made and year production was stoped on this engine

on the firewall theres a big black box its inside of it

No the first Year of el camino is 1959.

get a testlight ground it to the battery and turn the switch on and check the hotwire coming out of the module

Also if you can remove it from the distributor you can take it to a good auto parts store and they can bench test it for you.

Take the vin number to the Chevy dealer and they can make you another key.

235 Cubic Inch inline 6 cylinder and 283 Cubic Inch V8. Optional was the 283 Fuel Injected V8. The vast majority had the 283.

1972

*YOU SHOULD NOT BE LOOKING ON WIKI. IT IS NOT DEPENDENT. THANK YOU.

-department of wiki.