0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
What is the fluid capacity in the engine on a 2005 Chevy duramax 6.6?
It should hold 10 quarts of oil.
How do you remove inside door handles on an old Chevy?
they generally have horseshoe clips behind the handles.bend an old coathanger and get between the handle and the door panel.look for the clip and gently pull it out
Resetting a rear brake caliper in 2006 Chevy uplander?
the caliper needs a special tool. the piston does not push straight in. the spring needs to be released at the rear of the caliper. then using the special tool the piston twists back in to place
What causes a 93 Chevy to be sluggish?
Poor performance and lack of power can be caused by many things and you'll need to figure out what is going on.
Some of the more common are:
* improper ignition timing * damaged or worn out sensors * poor compression * worn or fouled sparkplugs * dirty air cleaner But it's relatively simple to check some of these. First, look at the air cleaner, maybe you can just replace it and everything will be fine.
Next, connect an engine diagnostic scanner to see if anything simple is wrong. The scanner can point out a lot of problems that the computer can detect.
After that, run a compression test. If the engine has low compression you won't be able to get much performance out of it. When you are checking the compression, examine the plugs. If they're fouled or the electrodes are excessively worn it might be a good time to replace them.
Good luck.
Where is the air conditioner relay on a 1991 Chevy 2500?
if your A/C light is flashing where you adjust temperature and its not blowing cold, try disconnecting the batter for a few minutes, and it will sometimes reset the programming for the air and stop it from flashing, and blow cold, it worked on my 1991 Chevy 2500
Where is the AC relay on a 91 Chevy c2500 PU?
I have a 93 c2500 pu and my tranny is acting up. It doesn't always want to shift outta first
Improper key Bring ignition switch to locksmith for re-keying
How much oil does a 1998 Chevy 1 ton 454 hold?
At least 5 quarts and possibly 6. Park the truck on a level surface. Drain the oil and change the filter. Add 5 quarts of oil, start the engine, and run for 45 seconds. Shut down and wait 45 minutes. Check the oil level and add until it is full. You now know.
How much oil does a 5.7 Chevy small block use?
Pre 89, 5. 89, and newer, 6. All the high performance motors used a windage tray systerm, and pan, that took 6, as well.
Is a Chevy 350 th transmission bellhousing?
No, the engine is not the transmission bellhousing. The bellhousing is a separate piece all together.
How do you change the serpentine belt on a Chevrolet s-10 1998?
It's pretty easy top cahnge a serpentine belt. There is a belt tensioner on the front of the engine. It should have a square hole in it for a 1/2 inch ratchet or breakover bar. using one of those tools, pull back on the spring loaded tensioner and you will get slack in the belt. Slip it off and replace it.
How much horsepower do Chevy 383 stroker engines have approximately?
This is a null question the 383 is a block so you need to have more details to find out the approximate HP of an
383 is a 350 stroke out so stfu block that anyway 383 can have many different range of horsepower my 69 camaro drag car have 650 hp with a 383 but it have alot of bolt on's
How can you get more power from 1992 Chevy 6.2L diesel engine?
You could put a banks turbo on it if you wanted it would give you more power.
Its a work horse engine designed to tow and move a truck around. Its no sports car. its a truck.
What did a 1957 Chevy Belair 4-door hard top cost new in 1957?
The MSRP for the 1957 Chevrolet Bel Air Sport Sedan was $2,424.32 for the base model, standard equipment only.
it could make it run rough bucause of the o2 sensor but its not going to hurt the motor other than running rough and use more gas
Will Chevy 194 straight 6 cylinder head fit a Chevy 250?
A Chevrolet 194 cubic inch 6 cylinder head will bolt onto a Chevy 250 c.i. 6 cylinder block. It will cause the 250 engine to have a higher compression ratio, as the 194 head has a smaller combustion chamber volume, usually given in cc's (cubic centimeters). It generally will not flow as well as a 230 or 250 head, as the ports are smaller, and it does not have the six exhaust ports separated in the same way as the later 230/250/292 heads. Otherwise, the external dimensions, and head-bolt locations are the same as with the heads of the later sixes.
It depends on what year the 194 head is as that only applies to the earlier 62-64 head.On 65-67 heads are basicly the same as the 230-250-292, in as they have separate exhaust runners, but still retain the smaller closed chambers. The only draw back is the smaller chamber shrouds the valves a bit and therefore some die grinder work needs to be done to unshroud them .I have used them successfuly on numerous 250 drag motors,mind you porting is needed and lump ports help above 6000 rpm, and they seem to favor bbc type cam specs, just depends on what use you have in mind. Below 6000 porting does wonders but the lumps seem to have no noticeable gains in power for street use , but bowl blending ( dondt go wild there or you will junk them )and gasket match them.I run a 63 nova with the lump ported heads 11.0-1 cr comp cams solid lifter 255 @ .050 .634 lift, pg trans 4500 converter, and this combo runs 10.90-11.10 depending on air conditions, ( no nitrous ).So make sure what year heads you have
As soon as you hook up hot wire to cigarette lighter the fuse blows on your 84 Chevy pickup why?
Load is too large for the circuit, or there is a short in the wire you are hooking up.
What is a 3882441 Chevy head casting?
there are a million different casting no. they do sell books of casting no. and also I've heard of a site where you can look up casting no. that's the best i can do . the books i have go back to the muscle cars, and they don't list your no. sorry.
To the best of my knowledge it's for an old 350 engine. A little bit high performance, about 300hp. I've got one down in my basement here in Sweden.
